[PATCH v2 6/7] arm64: dts: qcom: shikra-cqm-cqs-evk-imx577-camera: Add DT overlay

[Nihal Kumar Gupta]

On 12-06-2026 13:40, Vladimir Zapolskiy wrote:
>> +            imx577_ep1: endpoint {
>> +                link-frequencies = /bits/ 64 <600000000>;
>> +                data-lanes = <0 1 2 3>;
> 
> The numeration of data-lanes shall be started from 1, this has to be fixed.
> 
Thanks for pointing it.

Will fix in v3. On MIPI D-PHY, lane 0 is the clock lane, so data lanes
must start from 1 as per video-interfaces.yaml binding spec.
>> +                remote-endpoint = <&csiphy1_ep>;
>> +            };
>> +        };
>> +    }; 
>> +&tlmm {
>> +    cam1_reset_default: cam1-reset-default-state {
>> +        pins = "gpio33";
>> +        function = "gpio";
>> +        drive-strength = <2>;
>> +        bias-disable;
>> +    };
>> +};
> 
> Since it's a mezzanine specific pinctl assignment, it shall go to the
> correspondent .dtso file.
> 
> It's a concidence that one .dtso file is good enough for describing the
> mezzanine for two diffferent boards, but let's exploit it by keeping one
> dt overlay file as it is now.

Agreed, will move it to the .dtso in v3.

This also eliminates the identical cam1_reset_default block duplicated across 
CQM and CQS board files.

Will incorporate this for the IQS dtso file.
--
Regards,
Nihal Kumar Gupta