[PATCH v2 5/7] arm64: dts: qcom: shikra: Add pin configuration for mclks

[Vladimir Zapolskiy]

On 6/8/26 17:06, Nihal Kumar Gupta wrote:
> Add pinctrl configuration for the four available camera master clocks.
> 
> Signed-off-by: Nihal Kumar Gupta <nihal.gupta at oss.qualcomm.com>
> ---
>   arch/arm64/boot/dts/qcom/shikra.dtsi | 28 ++++++++++++++++++++++++++++
>   1 file changed, 28 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/qcom/shikra.dtsi b/arch/arm64/boot/dts/qcom/shikra.dtsi
> index fed71131491ebf6e261bfcd14b5d4a2624837878..2f0f7710c2897e140495afd8d4e8bde50f356096 100644
> --- a/arch/arm64/boot/dts/qcom/shikra.dtsi
> +++ b/arch/arm64/boot/dts/qcom/shikra.dtsi
> @@ -380,6 +380,34 @@ cci_i2c1_sleep: cci-i2c1-sleep-state {
>   				bias-pull-down;
>   			};
>   
> +			cam_mclk0_default: cam-mclk0-default-state {
> +				pins = "gpio34";
> +				function = "cam_mclk";
> +				drive-strength = <2>;
> +				bias-disable;
> +			};
> +
> +			cam_mclk1_default: cam-mclk1-default-state {
> +				pins = "gpio35";
> +				function = "cam_mclk";
> +				drive-strength = <2>;
> +				bias-disable;
> +			};
> +
> +			cam_mclk2_default: cam-mclk2-default-state {
> +				pins = "gpio96";
> +				function = "cam_mclk";
> +				drive-strength = <2>;
> +				bias-disable;
> +			};
> +
> +			cam_mclk3_default: cam-mclk3-default-state {
> +				pins = "gpio98";
> +				function = "cam_mclk";
> +				drive-strength = <2>;
> +				bias-disable;
> +			};
> +
>   			qup_uart0_default: qup-uart0-default-state {
>   				pins = "gpio0", "gpio1";
>   				function = "qup0_se0";
> 

Reviewed-by: Vladimir Zapolskiy <vladimir.zapolskiy at linaro.org>

-- 
Best wishes,
Vladimir