[PATCH RFC 9/9] arm64: dts: qcom: shikra-iqs-evk: Enable both ethernet ports

[Mohd Ayaan Anwar]

Enable both Gigabit Ethernet controllers.  Each port has a dedicated
PHY with a gpio-hog to assert the power-enable GPIO at boot,
pin-control for the RGMII and MDIO bus, and MTL queue configuration.

Signed-off-by: Mohd Ayaan Anwar <mohd.anwar at oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/shikra-iqs-evk.dts | 235 ++++++++++++++++++++++++++++
 1 file changed, 235 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/shikra-iqs-evk.dts b/arch/arm64/boot/dts/qcom/shikra-iqs-evk.dts
index fd691d53a0fa8179111b921bf3bacc08884b84fb..d69b63dbc8e44f1bcec064564236ea23673bfa1f 100644
--- a/arch/arm64/boot/dts/qcom/shikra-iqs-evk.dts
+++ b/arch/arm64/boot/dts/qcom/shikra-iqs-evk.dts
@@ -7,6 +7,7 @@
 
 #include "shikra-iqs-som.dtsi"
 #include "shikra-evk.dtsi"
+#include <dt-bindings/net/ti-dp83867.h>
 
 / {
 	model = "Qualcomm Technologies, Inc. Shikra IQS EVK";
@@ -68,6 +69,178 @@ vreg_pmu_ch1: ldo4 {
 	};
 };
 
+&ethernet0 {
+	status = "okay";
+	phy-handle = <&ethphy0>;
+	phy-mode = "rgmii-id";
+
+	pinctrl-names = "default";
+	pinctrl-0 = <&ethernet0_defaults>;
+
+	snps,mtl-rx-config = <&emac0_mtl_rx_setup>;
+	snps,mtl-tx-config = <&emac0_mtl_tx_setup>;
+
+	mdio {
+		compatible = "snps,dwmac-mdio";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		ethphy0: ethernet-phy at 7 {
+			compatible = "ethernet-phy-ieee802.3-c22";
+			reg = <7>;
+			reset-gpios = <&tlmm 135 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <50000>;
+			ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
+			ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
+		};
+	};
+
+	emac0_mtl_rx_setup: rx-queues-config {
+		snps,rx-queues-to-use = <4>;
+		snps,rx-sched-sp;
+
+		queue0 {
+			snps,dcb-algorithm;
+			snps,map-to-dma-channel = <0x0>;
+			snps,route-up;
+			snps,priority = <0x1>;
+		};
+
+		queue1 {
+			snps,dcb-algorithm;
+			snps,map-to-dma-channel = <0x1>;
+			snps,route-ptp;
+		};
+
+		queue2 {
+			snps,avb-algorithm;
+			snps,map-to-dma-channel = <0x2>;
+			snps,route-avcp;
+		};
+
+		queue3 {
+			snps,avb-algorithm;
+			snps,map-to-dma-channel = <0x3>;
+			snps,priority = <0xc>;
+		};
+	};
+
+	emac0_mtl_tx_setup: tx-queues-config {
+		snps,tx-queues-to-use = <4>;
+
+		queue0 {
+			snps,dcb-algorithm;
+		};
+
+		queue1 {
+			snps,dcb-algorithm;
+		};
+
+		queue2 {
+			snps,avb-algorithm;
+			snps,send_slope = <0x1000>;
+			snps,idle_slope = <0x1000>;
+			snps,high_credit = <0x3e800>;
+			snps,low_credit = <0xffc18000>;
+		};
+
+		queue3 {
+			snps,avb-algorithm;
+			snps,send_slope = <0x1000>;
+			snps,idle_slope = <0x1000>;
+			snps,high_credit = <0x3e800>;
+			snps,low_credit = <0xffc18000>;
+		};
+	};
+};
+
+&ethernet1 {
+	status = "okay";
+	phy-handle = <&ethphy1>;
+	phy-mode = "rgmii-id";
+
+	pinctrl-names = "default";
+	pinctrl-0 = <&ethernet1_defaults>;
+
+	snps,mtl-rx-config = <&emac1_mtl_rx_setup>;
+	snps,mtl-tx-config = <&emac1_mtl_tx_setup>;
+
+	mdio {
+		compatible = "snps,dwmac-mdio";
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		ethphy1: ethernet-phy at 7 {
+			compatible = "ethernet-phy-ieee802.3-c22";
+			reg = <7>;
+			reset-gpios = <&tlmm 151 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <50000>;
+			ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
+			ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_00_NS>;
+		};
+	};
+
+	emac1_mtl_rx_setup: rx-queues-config {
+		snps,rx-queues-to-use = <4>;
+		snps,rx-sched-sp;
+
+		queue0 {
+			snps,dcb-algorithm;
+			snps,map-to-dma-channel = <0x0>;
+			snps,route-up;
+			snps,priority = <0x1>;
+		};
+
+		queue1 {
+			snps,dcb-algorithm;
+			snps,map-to-dma-channel = <0x1>;
+			snps,route-ptp;
+		};
+
+		queue2 {
+			snps,avb-algorithm;
+			snps,map-to-dma-channel = <0x2>;
+			snps,route-avcp;
+		};
+
+		queue3 {
+			snps,avb-algorithm;
+			snps,map-to-dma-channel = <0x3>;
+			snps,priority = <0xc>;
+		};
+	};
+
+	emac1_mtl_tx_setup: tx-queues-config {
+		snps,tx-queues-to-use = <4>;
+
+		queue0 {
+			snps,dcb-algorithm;
+		};
+
+		queue1 {
+			snps,dcb-algorithm;
+		};
+
+		queue2 {
+			snps,avb-algorithm;
+			snps,send_slope = <0x1000>;
+			snps,idle_slope = <0x1000>;
+			snps,high_credit = <0x3e800>;
+			snps,low_credit = <0xffc18000>;
+		};
+
+		queue3 {
+			snps,avb-algorithm;
+			snps,send_slope = <0x1000>;
+			snps,idle_slope = <0x1000>;
+			snps,high_credit = <0x3e800>;
+			snps,low_credit = <0xffc18000>;
+		};
+	};
+};
+
 &remoteproc_cdsp {
 	firmware-name = "qcom/shikra/cdsp.mbn";
 
@@ -103,6 +276,68 @@ &sdhc_1 {
 	status = "okay";
 };
 
+&tlmm {
+	ethernet0_defaults: ethernet0-defaults-state {
+		rgmii-rx-pins {
+			pins = "gpio121", "gpio122", "gpio123",
+			       "gpio124", "gpio125", "gpio126";
+			function = "rgmii";
+			bias-disable;
+			drive-strength = <16>;
+		};
+		rgmii-tx-pins {
+			pins = "gpio127", "gpio128", "gpio129",
+			       "gpio130", "gpio131", "gpio132";
+			function = "rgmii";
+			bias-pull-up;
+			drive-strength = <16>;
+		};
+		rgmii-mdio-pins {
+			pins = "gpio133", "gpio134";
+			function = "rgmii";
+			bias-pull-up;
+			drive-strength = <16>;
+		};
+	};
+
+	ethernet1_defaults: ethernet1-defaults-state {
+		rgmii-rx-pins {
+			pins = "gpio137", "gpio138", "gpio139",
+			       "gpio140", "gpio141", "gpio142";
+			function = "rgmii";
+			bias-disable;
+			drive-strength = <16>;
+		};
+		rgmii-tx-pins {
+			pins = "gpio143", "gpio144", "gpio145",
+			       "gpio146", "gpio147", "gpio148";
+			function = "rgmii";
+			bias-pull-up;
+			drive-strength = <16>;
+		};
+		rgmii-mdio-pins {
+			pins = "gpio149", "gpio150";
+			function = "rgmii";
+			bias-pull-up;
+			drive-strength = <16>;
+		};
+	};
+
+	emac0_phy_en_hog: emac0-phy-en-hog {
+		gpio-hog;
+		gpios = <66 GPIO_ACTIVE_HIGH>;
+		output-high;
+		line-name = "emac0-phy-en";
+	};
+
+	emac1_phy_en_hog: emac1-phy-en-hog {
+		gpio-hog;
+		gpios = <53 GPIO_ACTIVE_HIGH>;
+		output-high;
+		line-name = "emac1-phy-en";
+	};
+};
+
 &uart8 {
 	status = "okay";
 

-- 
2.34.1