[PATCHv2 1/3] watchdog: sama5d4: fix shared IRQ and hardcoded timeout issues
Rosen Penev
rosenp at gmail.com
Mon Jun 8 13:09:31 PDT 2026
Fix three pre-existing issues in the sama5d4 watchdog driver:
1. Unsafe IRQF_SHARED | IRQF_NO_SUSPEND combination: The watchdog
interrupt is a dedicated peripheral line, not shared with other
devices.
2. Unconditional IRQ_HANDLED on shared line: The handler returned
IRQ_HANDLED even when the status register indicated no watchdog
interrupt was pending. Return IRQ_NONE in that case so the kernel
can properly detect spurious interrupts on the line.
3. Hardcoded 16-second timeout: sama5d4_wdt_init() unconditionally
used WDT_DEFAULT_TIMEOUT (16s) for the hardware timeout, ignoring
any timeout configured via device tree (watchdog_init_timeout) or
userspace. Pass wdd->timeout to sama5d4_wdt_init() so the
configured timeout is honored during probe and resume.
Assisted-by: opencode:big-pickle
Signed-off-by: Rosen Penev <rosenp at gmail.com>
---
drivers/watchdog/sama5d4_wdt.c | 19 ++++++++++---------
1 file changed, 10 insertions(+), 9 deletions(-)
diff --git a/drivers/watchdog/sama5d4_wdt.c b/drivers/watchdog/sama5d4_wdt.c
index 704b786cc2ec..f74f1e8956b5 100644
--- a/drivers/watchdog/sama5d4_wdt.c
+++ b/drivers/watchdog/sama5d4_wdt.c
@@ -169,11 +169,12 @@ static irqreturn_t sama5d4_wdt_irq_handler(int irq, void *dev_id)
else
reg = wdt_read(wdt, AT91_WDT_SR);
- if (reg) {
- pr_crit("Atmel Watchdog Software Reset\n");
- emergency_restart();
- pr_crit("Reboot didn't succeed\n");
- }
+ if (!reg)
+ return IRQ_NONE;
+
+ pr_crit("Atmel Watchdog Software Reset\n");
+ emergency_restart();
+ pr_crit("Reboot didn't succeed\n");
return IRQ_HANDLED;
}
@@ -197,11 +198,11 @@ static int of_sama5d4_wdt_init(struct device_node *np, struct sama5d4_wdt *wdt)
return 0;
}
-static int sama5d4_wdt_init(struct sama5d4_wdt *wdt)
+static int sama5d4_wdt_init(struct sama5d4_wdt *wdt, unsigned int timeout)
{
u32 reg, val;
- val = WDT_SEC2TICKS(WDT_DEFAULT_TIMEOUT);
+ val = WDT_SEC2TICKS(timeout);
/*
* When booting and resuming, the bootloader may have changed the
* watchdog configuration.
@@ -305,7 +306,7 @@ static int sama5d4_wdt_probe(struct platform_device *pdev)
set_bit(WDOG_HW_RUNNING, &wdd->status);
}
- ret = sama5d4_wdt_init(wdt);
+ ret = sama5d4_wdt_init(wdt, wdd->timeout);
if (ret)
return ret;
@@ -358,7 +359,7 @@ static int sama5d4_wdt_resume_early(struct device *dev)
* This should only be done when the registers are lost on suspend but
* there is no way to get this information right now.
*/
- sama5d4_wdt_init(wdt);
+ sama5d4_wdt_init(wdt, wdt->wdd.timeout);
if (watchdog_active(&wdt->wdd))
sama5d4_wdt_start(&wdt->wdd);
--
2.54.0
More information about the linux-arm-kernel
mailing list