[PATCH net-next v2 14/14] arm64: dts: qcom: qcs6490-rb3gen2: enable TC9564 with a single QCA8081 phy

Alex Elder elder at riscstar.com
Thu Jun 4 18:00:21 PDT 2026


From: Daniel Thompson <daniel at riscstar.com>

The QCS6490 RB3Gen2 includes a Toshiba TC9564 (a.k.a. Qualcomm QPS615).
TC9564 is an twin Ethernet-AVB/TSN bridge with an integrated PCIe switch.

Downstream PCIe switch port 3 has an embedded PCIe endpoint, which
includes two functions.  The GPIO controller embedded within the
TC9564 is accessed via memory-mapped I/O through the first PCIe
function's BAR4.

Both embedded PCIe functions have an attached Synopsys XGMAC, but
not all RB3gen2 builds include PHYs on both ports.  All versions
include a TC9564 combined with a single QCA8081 attached to eMAC1.

Add properties to the existing PCI nodes to describe how the TC9564 and
QCA8081 are connected to each other (and to the host SoC).

Signed-off-by: Daniel Thompson <daniel at riscstar.com>
Co-developed-by: Alex Elder <elder at riscstar.com>
Signed-off-by: Alex Elder <elder at riscstar.com>
---
Checkpatch notes:
  - pci1179 is not a recognized vendor ID
  - Some lines are longer than recommented

 arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts | 48 ++++++++++++++++++++
 1 file changed, 48 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
index e393ccf1884af..1d83b07360a33 100644
--- a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
+++ b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
@@ -308,6 +308,15 @@ vdd_ntn_1p8: regulator-vdd-ntn-1p8 {
 		regulator-enable-ramp-delay = <10000>;
 	};
 
+	qep_1p8: regulator-qep-1p8 {
+		compatible = "regulator-fixed";
+		regulator-name = "qep_1p8";
+		gpio = <&pm7325_gpios 8 GPIO_ACTIVE_HIGH>;
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <1800000>;
+		enable-active-high;
+	};
+
 	wcn6750-pmu {
 		compatible = "qcom,wcn6750-pmu";
 		pinctrl-0 = <&bt_en>;
@@ -938,19 +947,51 @@ pcie at 3,0 {
 			bus-range = <0x5 0xff>;
 
 			pci at 0,0 {
+				compatible = "pci1179,0220";
 				reg = <0x50000 0x0 0x0 0x0 0x0>;
 				#address-cells = <3>;
 				#size-cells = <2>;
 				device_type = "pci";
 				ranges;
+
+				tc9564_gpio0: gpio {
+					gpio-controller;
+					#gpio-cells = <2>;
+				};
 			};
 
 			pci at 0,1 {
+				compatible = "pci1179,0220";
 				reg = <0x50100 0x0 0x0 0x0 0x0>;
 				#address-cells = <3>;
 				#size-cells = <2>;
 				device_type = "pci";
 				ranges;
+
+				ethernet {
+					phy-mode = "sgmii";
+					phy-handle = <&tc9564_emac1_phy>;
+
+					mdio {
+						compatible = "snps,dwmac-mdio";
+						#address-cells = <1>;
+						#size-cells = <0>;
+
+						tc9564_emac1_phy: ethernet-phy at 1c {
+							compatible = "ethernet-phy-id004d.d101";
+							reg = <0x1c>;
+							snps,reset = <&tc9564_gpio0 1 GPIO_ACTIVE_LOW>;
+							reset-assert-us = <11000>;
+							reset-deassert-us = <70000>;
+
+							vdd18-supply = <&qep_1p8>;
+
+							pinctrl-names = "default";
+							pinctrl-0 = <&qep_irq_pin>;
+							interrupts-extended = <&tlmm 101 IRQ_TYPE_LEVEL_LOW>;
+						};
+					};
+				};
 			};
 		};
 	};
@@ -1524,6 +1565,13 @@ usb_hub_reset_state: usb-hub-reset-state {
 		drive-strength = <2>;
 		bias-disable;
 	};
+
+	qep_irq_pin: qep-irq-state {
+		pins = "gpio101";
+		function = "gpio";
+		drive-strength = <2>;
+		bias-disable;
+	};
 };
 
 &lpass_audiocc {
-- 
2.51.0




More information about the linux-arm-kernel mailing list