[PATCH] arm64: dts: broadcom: bcm2712: adjust display status

[Peter Robinson]

Hey Florian,

Not sure what happened to this, you said it was applied almost a year
ago but now I dig I don't see it upstream.

Was there a problem, or did it just fall through the cracks? Should I resend it?

Peter

On Tue, 7 Oct 2025 at 22:11, Florian Fainelli
<florian.fainelli at broadcom.com> wrote:
>
> On 9/24/2025 1:57 AM, Peter Robinson wrote:
> > Typically non critical IP in a SoC are disabled by
> > default in the SoC .dtsi and enabled on board specific
> > configs. There are usecases, such as some CM5 carrier
> > boards, where display output may not be desired or
> > connected. So disable them on the SoC .dtsi and enable
> > them on the RPi5 board.
> >
> > Signed-off-by: Peter Robinson <pbrobinson at gmail.com>
> > Cc: Dave Stevenson <dave.stevenson at raspberrypi.com>
> > Cc: Andrea della Porta <andrea.porta at suse.com>
> > Fixes: 25d77bdd7df2 ("arm64: dts: broadcom: Add display pipeline support to BCM2712")
>
> Applied to
> https://github.com/Broadcom/stblinux/commits/devicetree-arm64/next, thanks!
> --
> Florian
>