[PATCHv2] PCI: iproc: platform: use device functions instead of OF.

[Rob Herring]

On Mon, Jul 27, 2026 at 6:44 PM Rosen Penev <rosenp at gmail.com> wrote:
>
> Since this is supposed to be the higher layer file, use higher layer
> than OF to handle this. Remove OF headers as a result.
>
> Signed-off-by: Rosen Penev <rosenp at gmail.com>
> ---
>  v2: fix platform_get_resource() parameters.
>  drivers/pci/controller/pcie-iproc-platform.c | 31 ++++++++------------
>  1 file changed, 12 insertions(+), 19 deletions(-)
>
> diff --git a/drivers/pci/controller/pcie-iproc-platform.c b/drivers/pci/controller/pcie-iproc-platform.c
> index 4c9a0c4bb923..488ff737ec52 100644
> --- a/drivers/pci/controller/pcie-iproc-platform.c
> +++ b/drivers/pci/controller/pcie-iproc-platform.c
> @@ -10,12 +10,8 @@
>  #include <linux/slab.h>
>  #include <linux/interrupt.h>
>  #include <linux/platform_device.h>
> -#include <linux/of_address.h>
> -#include <linux/of_pci.h>
> -#include <linux/of_platform.h>
>  #include <linux/phy/phy.h>
>
> -#include "../pci.h"
>  #include "pcie-iproc.h"
>
>  static const struct of_device_id iproc_pcie_of_match_table[] = {
> @@ -40,11 +36,14 @@ static int iproc_pltfm_pcie_probe(struct platform_device *pdev)
>  {
>         struct device *dev = &pdev->dev;
>         struct iproc_pcie *pcie;
> -       struct device_node *np = dev->of_node;
> -       struct resource reg;
> +       struct resource *reg;
>         struct pci_host_bridge *bridge;
>         int ret;
>
> +       reg = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> +       if (!reg)
> +               return -ENODEV;
> +
>         bridge = devm_pci_alloc_host_bridge(dev, sizeof(*pcie));
>         if (!bridge)
>                 return -ENOMEM;
> @@ -52,26 +51,20 @@ static int iproc_pltfm_pcie_probe(struct platform_device *pdev)
>         pcie = pci_host_bridge_priv(bridge);
>
>         pcie->dev = dev;
> -       pcie->type = (uintptr_t)of_device_get_match_data(dev);
> -
> -       ret = of_address_to_resource(np, 0, &reg);
> -       if (ret < 0) {
> -               dev_err(dev, "unable to obtain controller resources\n");
> -               return ret;
> -       }
> +       pcie->type = (uintptr_t)device_get_match_data(dev);
>
> -       pcie->base = devm_pci_remap_cfgspace(dev, reg.start,
> -                                            resource_size(&reg));
> +       pcie->base = devm_pci_remap_cfgspace(dev, reg->start,
> +                                            resource_size(reg));
>         if (!pcie->base) {
>                 dev_err(dev, "unable to map controller registers\n");
>                 return -ENOMEM;
>         }
> -       pcie->base_addr = reg.start;
> +       pcie->base_addr = reg->start;
>
> -       if (of_property_read_bool(np, "brcm,pcie-ob")) {
> +       if (device_property_present(dev, "brcm,pcie-ob")) {

If the property is boolean, it should use read_bool and vice-versa.

>                 u32 val;
>
> -               ret = of_property_read_u32(np, "brcm,pcie-ob-axi-offset",
> +               ret = device_property_read_u32(dev, "brcm,pcie-ob-axi-offset",
>                                            &val);
>                 if (ret) {
>                         dev_err(dev,
> @@ -87,7 +80,7 @@ static int iproc_pltfm_pcie_probe(struct platform_device *pdev)
>          * core driver. For platforms that require explicit inbound mapping
>          * configuration, "dma-ranges" would have been present in DT
>          */
> -       pcie->need_ib_cfg = of_property_read_bool(np, "dma-ranges");
> +       pcie->need_ib_cfg = device_property_present(dev, "dma-ranges");

This is correct as dma-ranges may not be bool.

Rob