[PATCH] arm64: dts: renesas: beacon: Specify ethernet PHY reset timings

[Marek Vasut]

The KSZ9131RNX reference manual [1] DS00002841D page 131 FIGURE 6-2:
POWER SEQUENCE TIMING INTERNAL REGULATORS does not indicate how long
should the system wait after deassertion of the PHY reset and before
starting communication with the PHY via MDIO. Opt for the same value
as used for KSZ9031RNX, which is 300 us.

The KSZ9131RNX reference manual [1] DS00002841D page 131 FIGURE 6-2:
POWER SEQUENCE TIMING INTERNAL REGULATORS row tSR Stable supply
voltages to de-assertion of reset is at minimum 10 ms. Set DT
property reset-assert-us to 10ms because the KSZ9131RNX RM does
not explicitly spell out how long the reset has to be asserted,
but this at least covers the worst case scenario.

[1] https://ww1.microchip.com/downloads/aemDocuments/documents/UNG/ProductDocuments/DataSheets/00002841D.pdf

Signed-off-by: Marek Vasut <marek.vasut+renesas at mailbox.org>
---
Cc: Conor Dooley <conor+dt at kernel.org>
Cc: Geert Uytterhoeven <geert+renesas at glider.be>
Cc: Krzysztof Kozlowski <krzk+dt at kernel.org>
Cc: Magnus Damm <magnus.damm at gmail.com>
Cc: Rob Herring <robh at kernel.org>
Cc: devicetree at vger.kernel.org
Cc: linux-kernel at vger.kernel.org
Cc: linux-renesas-soc at vger.kernel.org
---
 arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi b/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
index f8442b6a85a75..8723e7a76c9dd 100644
--- a/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
+++ b/arch/arm64/boot/dts/renesas/beacon-renesom-som.dtsi
@@ -60,12 +60,14 @@ &avb {
 
 	phy0: ethernet-phy at 0 {
 		compatible = "ethernet-phy-id0022.1640";
 		reg = <0>;
 		interrupts-extended = <&gpio2 11 IRQ_TYPE_LEVEL_LOW>;
 		reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
+		reset-assert-us = <10000>;
+		reset-deassert-us = <300>;
 	};
 };
 
 &extal_clk {
 	clock-frequency = <16666666>;
 };
-- 
2.53.0