[PATCH v2 5/5] arm64: dts: microchip: lan969x: add QSPI nodes

[Robert Marko]

Add the required DT nodes for both QSPI controllers.

Signed-off-by: Robert Marko <robert.marko at sartura.hr>
---
Changes in v2:
* Make it apply on top of next-20260708, as SDMMC is not yet upstream

 arch/arm64/boot/dts/microchip/lan9691.dtsi | 33 ++++++++++++++++++++++
 1 file changed, 33 insertions(+)

diff --git a/arch/arm64/boot/dts/microchip/lan9691.dtsi b/arch/arm64/boot/dts/microchip/lan9691.dtsi
index ed997d87dd09..a8541c6a098d 100644
--- a/arch/arm64/boot/dts/microchip/lan9691.dtsi
+++ b/arch/arm64/boot/dts/microchip/lan9691.dtsi
@@ -396,6 +396,39 @@ clks: clock-controller at e00c00b4 {
 			clock-names = "cpu", "ddr", "sys";
 		};
 
+		qspi0: spi at e0804000 {
+			compatible = "microchip,lan9691-qspi";
+			reg = <0xe0804000 0x00000100>,
+			      <0x20000000 0x08000000>;
+			reg-names = "qspi_base", "qspi_mmap";
+			interrupts = <GIC_SPI 43 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&fabric_clk>, <&clks GCK_ID_QSPI0>;
+			clock-names = "pclk", "gclk";
+			assigned-clocks = <&clks GCK_ID_QSPI0>;
+			assigned-clock-rates = <100000000>;
+			dmas = <&dma AT91_XDMAC_DT_PERID(1)>,
+			       <&dma AT91_XDMAC_DT_PERID(0)>;
+			dma-names = "tx", "rx";
+			#address-cells = <1>;
+			#size-cells = <0>;
+			status = "disabled";
+		};
+
+		qspi2: spi at e0834000 {
+			compatible = "microchip,lan9691-qspi";
+			reg = <0xe0834000 0x00000100>,
+			      <0x30000000 0x04000000>;
+			reg-names = "qspi_base", "qspi_mmap";
+			interrupts = <GIC_SPI 66 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&fabric_clk>, <&clks GCK_ID_QSPI2>;
+			clock-names = "pclk", "gclk";
+			assigned-clocks = <&clks GCK_ID_QSPI2>;
+			assigned-clock-rates = <100000000>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			status = "disabled";
+		};
+
 		reset: reset-controller at e201000c {
 			compatible = "microchip,lan9691-switch-reset",
 				     "microchip,lan966x-switch-reset";
-- 
2.55.0