[PATCH v10 4/7] i2c: davinci: calculate bus freq from Hz instead of kHz

[Marcus Folkesson]

On Wed, Jul 08, 2026 at 10:30:32PM +0300, Andy Shevchenko wrote:
> On Wed, Jul 08, 2026 at 02:16:16PM +0200, Marcus Folkesson wrote:
> > The bus frequency is unnecessarily converted between Hz and kHz in
> > several places.
> > This is probably an old legacy from the old times (pre-devicetrees)
> > when the davinci_i2c_platform_data took the bus_freq in kHz.
> > 
> > Stick to Hz.
> 
> ...
> 
> > -#define DAVINCI_I2C_DEFAULT_BUS_FREQ	100000
> > -
> 
> You need to rebase this on top of the i2c-next.

Thanks, will do.
> 
> ...
> 
> > +	/* standard bus frequency */
> > +	unsigned int		bus_freq_hz;
> 
> While at it, I would dare to suggest _Hz as we started doing in IIO (id est
> we start following more closely the SI units in the suffixes of constant
> definitions and variables to be case sensitive).

Sounds good, I will change to Hz.

> 
> ...
> 
> >  	r = device_property_read_u32(&pdev->dev, "clock-frequency", &prop);
> >  	if (r)
> > -		prop = DAVINCI_I2C_DEFAULT_BUS_FREQ;
> > +		prop = I2C_MAX_STANDARD_MODE_FREQ;
> >  
> 
> See above about rebase.
> 
> -- 
> With Best Regards,
> Andy Shevchenko
> 
Best regards,
Marcus Folkesson