[PATCH v10 33/36] phy: rockchip: usbdp: Rename mode to hw_mode
Sebastian Reichel
sebastian.reichel at collabora.com
Fri Jul 3 11:13:49 PDT 2026
Rename mode field to hw_mode to make clear that this is the modes
currently supported by the hardware, but not necessarily requested
by software. I.e. it is only set by either the USB-C state machine
or device-tree if the PHY is used in a fixed routing setup.
Signed-off-by: Sebastian Reichel <sebastian.reichel at collabora.com>
---
drivers/phy/rockchip/phy-rockchip-usbdp.c | 46 +++++++++++++++----------------
1 file changed, 23 insertions(+), 23 deletions(-)
diff --git a/drivers/phy/rockchip/phy-rockchip-usbdp.c b/drivers/phy/rockchip/phy-rockchip-usbdp.c
index 3fb6eea2979b..e2cd72643a7d 100644
--- a/drivers/phy/rockchip/phy-rockchip-usbdp.c
+++ b/drivers/phy/rockchip/phy-rockchip-usbdp.c
@@ -174,7 +174,7 @@ struct rk_udphy {
/* PHY status management */
bool flip;
bool phy_needs_reinit;
- u8 mode;
+ u8 hw_mode; /* modes currently supported by hardware */
u8 status;
/* utilized for USB */
@@ -579,18 +579,18 @@ static void rk_udphy_dp_lane_enable(struct rk_udphy *udphy, int dp_lanes)
CMN_DP_CMN_RSTN, FIELD_PREP(CMN_DP_CMN_RSTN, 0x0));
}
-static void rk_udphy_mode_set(struct rk_udphy *udphy, u8 mode)
+static void rk_udphy_mode_set(struct rk_udphy *udphy, u8 hw_mode)
{
- if (udphy->mode == mode)
+ if (udphy->hw_mode == hw_mode)
return;
udphy->phy_needs_reinit = true;
- udphy->mode = mode;
+ udphy->hw_mode = hw_mode;
}
static void rk_udphy_set_typec_state(struct rk_udphy *udphy, unsigned long state)
{
- u8 mode;
+ u8 hw_mode;
switch (state) {
case TYPEC_DP_STATE_C:
@@ -599,7 +599,7 @@ static void rk_udphy_set_typec_state(struct rk_udphy *udphy, unsigned long state
udphy->lane_mux_sel[1] = PHY_LANE_MUX_DP;
udphy->lane_mux_sel[2] = PHY_LANE_MUX_DP;
udphy->lane_mux_sel[3] = PHY_LANE_MUX_DP;
- mode = UDPHY_MODE_DP;
+ hw_mode = UDPHY_MODE_DP;
udphy->dp_lanes = 4;
break;
@@ -616,12 +616,12 @@ static void rk_udphy_set_typec_state(struct rk_udphy *udphy, unsigned long state
udphy->lane_mux_sel[2] = PHY_LANE_MUX_DP;
udphy->lane_mux_sel[3] = PHY_LANE_MUX_DP;
}
- mode = UDPHY_MODE_DP_USB;
+ hw_mode = UDPHY_MODE_DP_USB;
udphy->dp_lanes = 2;
break;
}
- rk_udphy_mode_set(udphy, mode);
+ rk_udphy_mode_set(udphy, hw_mode);
}
static void rk_udphy_set_typec_default_mapping(struct rk_udphy *udphy)
@@ -744,7 +744,7 @@ static int rk_udphy_status_check(struct rk_udphy *udphy)
int ret;
/* LCPLL check */
- if (udphy->mode & UDPHY_MODE_USB) {
+ if (udphy->hw_mode & UDPHY_MODE_USB) {
ret = regmap_read_poll_timeout(udphy->pma_regmap, CMN_ANA_LCPLL_DONE_OFFSET,
val, (val & CMN_ANA_LCPLL_AFC_DONE) &&
(val & CMN_ANA_LCPLL_LOCK_DONE), 200, 100000);
@@ -779,15 +779,15 @@ static int rk_udphy_init(struct rk_udphy *udphy)
int ret;
dev_dbg(udphy->dev, "reinit PHY with USB3=%s and DP=%s (%u lanes) flipped=%s\n",
- str_on_off(udphy->mode & UDPHY_MODE_USB),
- str_on_off(udphy->mode & UDPHY_MODE_DP),
+ str_on_off(udphy->hw_mode & UDPHY_MODE_USB),
+ str_on_off(udphy->hw_mode & UDPHY_MODE_DP),
udphy->dp_lanes, str_yes_no(udphy->flip));
rk_udphy_reset_assert_all(udphy);
usleep_range(10000, 11000);
/* enable rx lfps for usb */
- if (udphy->mode & UDPHY_MODE_USB)
+ if (udphy->hw_mode & UDPHY_MODE_USB)
rk_udphy_grfreg_write(udphy->udphygrf, &cfg->grfcfg.rx_lfps, true);
/* Step 1: power on pma and deassert apb rstn */
@@ -824,13 +824,13 @@ static int rk_udphy_init(struct rk_udphy *udphy)
FIELD_PREP(CMN_DP_LANE_EN_ALL, 0));
/* Step 4: deassert init rstn and wait for 200ns from datasheet */
- if (udphy->mode & UDPHY_MODE_USB) {
+ if (udphy->hw_mode & UDPHY_MODE_USB) {
ret = rk_udphy_reset_deassert(udphy, "init");
if (ret)
goto assert_resets;
}
- if (udphy->mode & UDPHY_MODE_DP) {
+ if (udphy->hw_mode & UDPHY_MODE_DP) {
regmap_update_bits(udphy->pma_regmap, CMN_DP_RSTN_OFFSET,
CMN_DP_INIT_RSTN,
FIELD_PREP(CMN_DP_INIT_RSTN, 0x1));
@@ -839,7 +839,7 @@ static int rk_udphy_init(struct rk_udphy *udphy)
udelay(1);
/* Step 5: deassert cmn/lane rstn */
- if (udphy->mode & UDPHY_MODE_USB) {
+ if (udphy->hw_mode & UDPHY_MODE_USB) {
ret = rk_udphy_reset_deassert(udphy, "cmn");
if (ret)
goto assert_resets;
@@ -898,7 +898,7 @@ static int rk_udphy_parse_lane_mux_data(struct rk_udphy *udphy)
num_lanes = device_property_count_u32(udphy->dev, "rockchip,dp-lane-mux");
if (num_lanes < 0) {
dev_dbg(udphy->dev, "no dp-lane-mux, following dp alt mode\n");
- udphy->mode = UDPHY_MODE_USB;
+ udphy->hw_mode = UDPHY_MODE_USB;
return 0;
}
@@ -927,10 +927,10 @@ static int rk_udphy_parse_lane_mux_data(struct rk_udphy *udphy)
}
}
- udphy->mode = UDPHY_MODE_DP;
+ udphy->hw_mode = UDPHY_MODE_DP;
udphy->dp_lanes = num_lanes;
if (num_lanes == 1 || num_lanes == 2) {
- udphy->mode |= UDPHY_MODE_USB;
+ udphy->hw_mode |= UDPHY_MODE_USB;
udphy->flip = (udphy->lane_mux_sel[0] == PHY_LANE_MUX_DP) ||
(udphy->lane_mux_sel[1] == PHY_LANE_MUX_DP);
}
@@ -989,7 +989,7 @@ static int rk_udphy_power_on(struct rk_udphy *udphy, u8 mode)
{
int ret;
- if (!(udphy->mode & mode)) {
+ if (!(udphy->hw_mode & mode)) {
dev_info(udphy->dev, "mode 0x%02x is not support\n", mode);
return 0;
}
@@ -1004,7 +1004,7 @@ static int rk_udphy_power_on(struct rk_udphy *udphy, u8 mode)
if (ret)
return ret;
- if (!udphy->hs && udphy->mode & UDPHY_MODE_USB)
+ if (!udphy->hs && udphy->hw_mode & UDPHY_MODE_USB)
rk_udphy_u3_port_disable(udphy, false);
udphy->phy_needs_reinit = false;
@@ -1033,7 +1033,7 @@ static int rk_udphy_power_on(struct rk_udphy *udphy, u8 mode)
static void rk_udphy_power_off(struct rk_udphy *udphy, u8 mode)
{
- if (!(udphy->mode & mode)) {
+ if (!(udphy->hw_mode & mode)) {
dev_info(udphy->dev, "mode 0x%02x is not support\n", mode);
return;
}
@@ -1292,7 +1292,7 @@ static int rk_udphy_usb3_phy_init(struct phy *phy)
guard(mutex)(&udphy->mutex);
/* DP only or high-speed, disable U3 port */
- if (!(udphy->mode & UDPHY_MODE_USB) || udphy->hs) {
+ if (!(udphy->hw_mode & UDPHY_MODE_USB) || udphy->hs) {
rk_udphy_u3_port_disable(udphy, true);
return 0;
}
@@ -1307,7 +1307,7 @@ static int rk_udphy_usb3_phy_exit(struct phy *phy)
guard(mutex)(&udphy->mutex);
/* DP only or high-speed */
- if (!(udphy->mode & UDPHY_MODE_USB) || udphy->hs) {
+ if (!(udphy->hw_mode & UDPHY_MODE_USB) || udphy->hs) {
udphy->status &= ~UDPHY_MODE_USB;
return 0;
}
--
2.53.0
More information about the linux-arm-kernel
mailing list