[PATCH v2] arm64: dts: broadcom: bcm2712: Add V3D device node

[Krzysztof Kozlowski]

On 16/01/2026 11:56, Peter Robinson wrote:
>>>> +
>>>> +&v3d {
>>>> +    clocks = <&firmware_clocks 5>;
>>>
>>> Looking at the upstream DT [1] I think this also needs a clock-names entry.
>>
>> Differently from the `hvs` node [1] you sent (which specifies clock-
>> names), the `v3d` binding [2] doesn't have a clock-names property.
>> Therefore, it is not needed.
> 
> There's a name in the clk driver [1] so maybe the bindings should be updated?

That's a clock provider, not consumer.

> 
> https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/drivers/clk/bcm/clk-raspberrypi.c#n26



Best regards,
Krzysztof