[PATCH 2/2] arm64: dts: amlogic: add the type-c controller on Radxa Zero 2

[Krzysztof Kozlowski]

On 14/01/2026 23:48, Ricardo Pardini via B4 Relay wrote:
>  };
>  
> +/* Also exposed on the 40-pin header: SDA pin 3, SCL pin 5 */
> +&i2c3 {
> +	pinctrl-0 = <&i2c3_sda_a_pins>, <&i2c3_sck_a_pins>;
> +	pinctrl-names = "default";
> +	status = "okay";
> +
> +	fusb302 at 22 {

Node names should be generic. See also an explanation and list of
examples (not exhaustive) in DT specification:
https://devicetree-specification.readthedocs.io/en/latest/chapter2-devicetree-basics.html#generic-names-recommendation
If you cannot find a name matching your device, please check in kernel
sources for similar cases or you can grow the spec (via pull request to
DT spec repo).

> +		compatible = "fcs,fusb302";
> +		reg = <0x22>;
> +
> +		pinctrl-0 = <&fusb302_irq_pins>;
> +		pinctrl-names = "default";
> +		interrupt-parent = <&gpio_intc>;
> +		interrupts = <13 IRQ_TYPE_LEVEL_LOW>;
> +
> +		vbus-supply = <&ao_5v>;
> +
> +		status = "okay";

Not needed or was it disabled anywhere?


Best regards,
Krzysztof