[PATCH 3/3] dt-bindings: PCI: fsl,imx6q-pcie: Remove the deprecated "reset-gpio-active-high" property

[Krzysztof Kozlowski]

On 15/01/2026 08:18, Sherry Sun wrote:
> Commit 2e81122d681c ("PCI: imx6: Convert to use agnostic GPIO API")
> deleted the support of "reset-gpio-active-high" property in imx6 PCIe
> driver. This deprecated preoperty is no longer used in any DTS file,
> let's also remove this in dt-binding.
> 
> Signed-off-by: Sherry Sun <sherry.sun at nxp.com>
> ---
>  Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml | 6 ------
>  1 file changed, 6 deletions(-)
> 
> diff --git a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> index 12a01f7a5744..6b18264afecf 100644
> --- a/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> +++ b/Documentation/devicetree/bindings/pci/fsl,imx6q-pcie.yaml
> @@ -63,12 +63,6 @@ properties:
>        reset signal. It's not polarity aware and defaults to active-low reset
>        sequence (L=reset state, H=operation state) (optional required).
>  
> -  reset-gpio-active-high:
> -    description: If present then the reset sequence using the GPIO
> -      specified in the "reset-gpio" property is reversed (H=reset state,
> -      L=operation state) (optional required).

You had one command to run before preparing such patch:

git grep reset-gpio-active-high

so now you made this ABI undocumented.

Best regards,
Krzysztof