[PATCH v2 2/2] arm64: dts: amlogic: s4: fix mmc clock assignment

[Jerome Brunet]

MMC A and C are mis-represented as having their "clkin0" input connected to
xtal while it is actually connected to the MMC clock, probably in an
attempt to provide 24MHz to the device on this input.

Fix this and assign the clock to 24MHz to actually provide the required
rate.

Fixes: 3ab9d54b5d84 ("arm64: dts: amlogic: enable some device nodes for S4")
Tested-by: Nick Xie <nick at khadas.com>
Signed-off-by: Jerome Brunet <jbrunet at baylibre.com>
---
 arch/arm64/boot/dts/amlogic/meson-s4.dtsi | 12 ++++++++++--
 1 file changed, 10 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/amlogic/meson-s4.dtsi b/arch/arm64/boot/dts/amlogic/meson-s4.dtsi
index 62538fd9db6b..6324d1eb5994 100644
--- a/arch/arm64/boot/dts/amlogic/meson-s4.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-s4.dtsi
@@ -819,13 +819,17 @@ sdio: mmc at fe088000 {
 			reg = <0x0 0xfe088000 0x0 0x800>;
 			interrupts = <GIC_SPI 176 IRQ_TYPE_LEVEL_HIGH>;
 			clocks = <&clkc_periphs CLKID_SDEMMC_A>,
-				 <&xtal>,
+				 <&clkc_periphs CLKID_SD_EMMC_A>,
 				 <&clkc_pll CLKID_FCLK_DIV2>;
 			clock-names = "core", "clkin0", "clkin1";
 			resets = <&reset RESET_SD_EMMC_A>;
 			cap-sdio-irq;
 			keep-power-in-suspend;
 			status = "disabled";
+
+			assigned-clocks = <&clkc_periphs CLKID_SD_EMMC_A>;
+			assigned-clock-parents = <0>;
+			assigned-clock-rates = <24000000>;
 		};
 
 		sd: mmc at fe08a000 {
@@ -849,13 +853,17 @@ emmc: mmc at fe08c000 {
 			reg = <0x0 0xfe08c000 0x0 0x800>;
 			interrupts = <GIC_SPI 178 IRQ_TYPE_EDGE_RISING>;
 			clocks = <&clkc_periphs CLKID_NAND>,
-				 <&xtal>,
+				 <&clkc_periphs CLKID_SD_EMMC_C>,
 				 <&clkc_pll CLKID_FCLK_DIV2>;
 			clock-names = "core", "clkin0", "clkin1";
 			resets = <&reset RESET_NAND_EMMC>;
 			no-sdio;
 			no-sd;
 			status = "disabled";
+
+			assigned-clocks = <&clkc_periphs CLKID_SD_EMMC_C>;
+			assigned-clock-parents = <0>;
+			assigned-clock-rates = <24000000>;
 		};
 	};
 };

-- 
2.47.3