[PATCH v3 5/9] dt-bindings: usb: dwc3: Document ST STM32MP2 DWC3 xHCI USB controller

[Marek Vasut]

On 8/27/26 2:59 PM, Krzysztof Kozlowski wrote:

[...]

>> +++ b/Documentation/devicetree/bindings/usb/st,stm32mp25-dwc3.yaml
>> @@ -0,0 +1,97 @@
>> +# SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
>> +%YAML 1.2
>> +---
>> +$id: http://devicetree.org/schemas/usb/st,stm32mp25-dwc3.yaml#
>> +$schema: http://devicetree.org/meta-schemas/core.yaml#
>> +
>> +title: STMicroelectronics STM32 MPU DWC3 USB SoC controller
>> +
>> +description:
>> +  The STM32 MPU DWC3 USB SoC controller block supports both
>> +  Host(SS/HS/FS/LS) and Device(SS/HS/FS) mode operation
>> +
>> +maintainers:
>> +  - Fabrice Gasnier <fabrice.gasnier at foss.st.com>
>> +  - Marek Vasut <marex at nabladev.com>
>> +
>> +allOf:
>> +  - $ref: snps,dwc3-common.yaml#
> 
> Honestly, I am lost. It seems this resolves my comment at v2, but now I
> went through patchset from Fabrice Gasnier which was ON TOP of this
> patch adding this line.

I think the stuff Fabrice sent was on top of V2.

> It is not your fault, although if there are pending comments expressed
> not via review but via patchses on top of things being reviewed, then
> can you check for them?
I did, while briefly reviewing that series.