[PATCH 04/10] scsi: ufs: Move Versal2 M-PHY CREG access helpers into ufshcd-dwc

[Larisa Ileana Grigore]

On 8/26/2026 6:36 PM, Bart Van Assche wrote:
> On 8/26/26 6:40 AM, Larisa Grigore wrote:
>> +int ufshcd_dwc_phy_reg_write(struct ufs_hba *hba, u32 addr, u32 val)
>> +{
>> +    struct ufshcd_dme_attr_val phy_write_attrs[] = {
>> +        { UIC_ARG_MIB(CBCREGADDRLSB), 0, DME_LOCAL },
>> +        { UIC_ARG_MIB(CBCREGADDRMSB), 0, DME_LOCAL },
>> +        { UIC_ARG_MIB(CBCREGWRLSB), 0, DME_LOCAL },
>> +        { UIC_ARG_MIB(CBCREGWRMSB), 0, DME_LOCAL },
>> +        { UIC_ARG_MIB(CBCREGRDWRSEL), 1, DME_LOCAL },
>> +        { UIC_ARG_MIB(VS_MPHYCFGUPDT), 1, DME_LOCAL }
>> +    };
> 
> This array and similar arrays should be declared 'static const'.
> 
> Thanks,
> 
> Bart.

Thanks for the review Bart! I did not make the arrays static because 
their entries depend on the runtime addr and val arguments. A shared 
static buffer would be racy if two callers ran concurrently. However, I 
can make the arrays const in v2 by moving the addr/val-derived bytes 
directly into the initializer.

Regards,
Larisa