[PATCH 2/7] soc: qcom: geni-se: Populate clk_perf_tbl with SE source clock frequencies from perf OPP table

[Praveen Talari]

HI Konrad,

On 24-08-2026 20:26, Konrad Dybcio wrote:
> On 8/4/26 9:57 PM, Praveen Talari wrote:
>> Currently, on the SA8255P platform, protocol drivers attached via
>> geni_se_domain_attach() treat each OPP on the perf domain as directly
>> corresponding to a protocol value such as a baudrate or requested
>> frequency, and simply request that OPP via
> [...]
>
>> @@ -1175,6 +1181,29 @@ int geni_se_domain_attach(struct geni_se *se)
>>   	else if (ret < 0)
>>   		return ret;
>>   
>> +	perf_dev = se->pd_list->pd_devs[DOMAIN_IDX_PERF];
>> +
>> +	num_opps = dev_pm_opp_get_opp_count(perf_dev);
>> +	if (num_opps <= 0)
>> +		return num_opps < 0 ? num_opps : -ENODEV;
> if (num_opps < 0)
> 	return num_opps;
> if (num_opps == 0)
> 	return -ENODEV;
>
>> +
>> +	se->clk_perf_tbl = devm_kcalloc(se->dev, num_opps,
>> +					sizeof(*se->clk_perf_tbl),
>> +					GFP_KERNEL);
>> +	if (!se->clk_perf_tbl)
>> +		return -ENOMEM;
>> +
>> +	for (i = 0, level = 0; i < num_opps; i++, level++) {
> One iterator is sufficient here

level is not acting as a loop iterator here. It represents the OPP 
performance level

returned by dev_pm_opp_find_level_ceil(), which may advance to a value 
greater

than level + 1 depending on the available OPP table entries. The array 
index, however,

must advance sequentially for each populated entry. Therefore, separate 
variables are needed.


Thanks,

Praveen Talari

>
> Konrad