[PATCH 3/7] soc: qcom: geni-se: Add helper to set SE clock rate via OPP

[Praveen Talari]

On 24-08-2026 20:28, Konrad Dybcio wrote:
> On 8/4/26 9:57 PM, Praveen Talari wrote:
>> GENI protocol drivers need a common way to scale the SE source clock
>> through the OPP framework. However, the device that owns the OPP table
>> differs depending on how the SE resources are managed. For Linux clock
>> managed platforms, the OPP table is associated with the SE device,
>> whereas on firmware-managed platforms it is associated with the
>> performance power-domain device. This requires protocol drivers to be
>> aware of the underlying resource management model when requesting
>> frequency changes.
> [...]
>
>> +/**
>> + * geni_se_set_rate() - Set the SE source clock rate via the OPP framework.
>> + * @se: Pointer to the struct geni_se instance.
>> + * @freq: The source clock frequency to set.
>> + *
>> + * Applies the given frequency through dev_pm_opp_set_rate(), targeting the
>> + * perf domain device when the SE has power domains attached (firmware
>> + * managed path), or se->dev otherwise (Linux clock managed path).
>> + *
>> + * Return: 0 on success, or a negative error code on failure.
>> + */
>> +int geni_se_set_rate(struct geni_se *se, unsigned long freq)
>> +{
>> +	struct device *perf_dev = se->dev;
>> +
>> +	if (se->pd_list && se->pd_list->pd_devs[DOMAIN_IDX_PERF])
> The latter will always be true if the former is

Sure. I'll simplify the condition to just check se->pd_list.

Thanks,

Praveen Talari

>
> Konrad
>
>> +		perf_dev = se->pd_list->pd_devs[DOMAIN_IDX_PERF];
>> +
>> +	return se->has_opp ? dev_pm_opp_set_rate(perf_dev, freq) : 0;