[PATCH 4/7] serial: qcom-geni: Use geni_se_set_rate() for source clock configuration

[Mukesh Savaliya]

On 8/5/2026 1:27 AM, Praveen Talari wrote:
> The driver calls dev_pm_opp_set_rate() directly on uport->dev to apply
> the computed source clock frequency, and dispatches baud rate handling
> through a per-variant dev_data->set_rate() callback that either
> recalculates the clock divider (Linux clock managed path) or selects
> a performance level via geni_se_set_perf_level() (SA8255P firmware
> managed path).
> 
> Now that geni_se_domain_attach() populates se->clk_perf_tbl from the
> perf domain's OPP table, geni_se_clk_freq_match() can resolve a source
> clock frequency and divider on the SA8255P path the same way it
> already does for the Linux clock managed path. This removes the need
> for a separate perf-level based set_rate implementation, so
> geni_serial_set_rate() can be called unconditionally and
> dev_data->set_rate can be dropped.
> 
> Switch to calling geni_serial_set_rate() directly from
> qcom_geni_serial_set_termios(), and use geni_se_set_rate() in place of
> dev_pm_opp_set_rate() so the frequency is applied to the correct
> device (the perf domain device on the firmware managed path, or
> uport->dev otherwise) without the driver needing to know which
> resources_init variant is in use. Remove the now-unused set_rate field
> from struct qcom_geni_device_data and its per-variant initializers.
> 

This commit message seems quite long and repeats the rationale few times:
1. removes need for perf-level based set_rate
2. call geni_serial_set_rate unconditionally
3. use geni_se_set_rate instead of dev_pm_opp_set_rate

Review, if below makes sense, tried to shorten it.

geni_se_set_rate() now abstracts source clock programming for both
clock-managed and SCMI/perf-domain managed GENI instances.

Use geni_serial_set_rate() unconditionally from
qcom_geni_serial_set_termios() and remove the per-variant set_rate()
callback. This allows the UART driver to configure source clocks
without needing to know whether resources are managed through Linux
clocks or the SA8255P firmware-controlled performance domain.


> Signed-off-by: Praveen Talari <praveen.talari at oss.qualcomm.com>
> ---