[PATCH v2 RESEND] arm64: dts: nuvoton: ma35d1: add CAN nodes

[Marc Kleine-Budde]

On 08.07.2026 16:24:57, Zi-Yu Chen wrote:
> Add controller nodes for the four Bosch M_CAN blocks found on the
> Nuvoton MA35D1 SoC.
>
> Additionally, configure pinctrl and enable CAN1 and CAN3 on the
> MA35D1 SOM board. Also, update the APLL frequency to 200MHz to ensure
> the CAN controllers receive the required input clock for 50MHz operation.

50 MHz is an unusual CAN clock frequency. Better use a multiple of 40
MHz. Within the limits of the m_can IP core, the higher the multiple the
better.

regards,
Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde          |
Embedded Linux                   | https://www.pengutronix.de |
Vertretung Nürnberg              | Phone: +49-5121-206917-129 |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-9   |
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 228 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20260824/5134a4ff/attachment.sig>