[PATCH v3] i2c: xiic: restore non-managed runtime PM to fix clk WARN flood

[Andy Shevchenko]

On Wed, Aug 19, 2026 at 09:45:41AM +0300, Andy Shevchenko wrote:
> On Tue, Aug 18, 2026 at 08:35:10AM -0700, Abdurrahman Hussain wrote:

...

> >  	pm_runtime_set_autosuspend_delay(dev, XIIC_PM_TIMEOUT);
> >  	pm_runtime_use_autosuspend(dev);
> > -	ret = devm_pm_runtime_set_active_enabled(dev);
> > -	if (ret)
> > -		return ret;
> > +	/*
> > +	 * Enable runtime PM by hand: devm_pm_runtime_set_active_enabled()
> > +	 * tears down in an order that races the devm-enabled clock release and
> > +	 * makes clk_core_disable() WARN (see xiic_i2c_remove()).
> > +	 */
> > +	pm_runtime_set_active(dev);
> > +	pm_runtime_enable(dev);
> >  
> >  	/* SCL frequency configuration */
> >  	i2c->input_clk = clk_get_rate(i2c->clk);
> 
> >  	ret = devm_request_threaded_irq(dev, irq, NULL, xiic_process,
> >  					IRQF_ONESHOT, pdev->name, i2c);
> >  	if (ret)
> > -		return ret;
> > +		goto err_pm_disable;
> 
> This might be problematic now. You need to unwind the IRQ request in non-devm
> manner as well. Scenario is that IRQ comes exactly after PM is disabled
> in the error path. Is it a problem today? What about tomorrow (assuming some
> new chips / code is added)?

(To be clear: I'm talking about next call(s) that may fail, like xiic_reinit()
 later in the probe.)

> The rule of thumb is that, no devm_*() call should be followed by a goto.

-- 
With Best Regards,
Andy Shevchenko