[PATCH 10/25] ARM: dts: rockchip: Add USB2 PHY and USB3-OTG (DWC3) nodes for RV1106

[Vladislav Leonov]

Add the u2phy node with its otg-port child, using the disconnect
interrupt in addition to otg-bvalid/otg-id/linestate.

Also add the usbdrd/usbdrd_dwc3 nodes for the DWC3 controller behind
the PHY, reusing the "rockchip,rk3399-dwc3" glue compatible and the
snps quirks already used by other Rockchip DWC3 platforms, since
RV1106 does not need a dedicated glue driver.

Both nodes default to status = "disabled" and are enabled per-board.

Signed-off-by: Vladislav Leonov <vlad at zlab.su>
---

 arch/arm/boot/dts/rockchip/rv1106.dtsi | 48 ++++++++++++++++++++++++++
 1 file changed, 48 insertions(+)

diff --git a/arch/arm/boot/dts/rockchip/rv1106.dtsi b/arch/arm/boot/dts/rockchip/rv1106.dtsi
index 71dd3dcc386c..43db3b1dd4b8 100644
--- a/arch/arm/boot/dts/rockchip/rv1106.dtsi
+++ b/arch/arm/boot/dts/rockchip/rv1106.dtsi
@@ -180,6 +180,30 @@ saradc: adc at ff3c0000 {
 			status = "disabled";
 		};
 
+		u2phy: usb2-phy at ff3e0000 {
+			compatible = "rockchip,rv1106-usb2phy";
+			reg = <0xff3e0000 0x8000>;
+			clocks = <&cru CLK_REF_USBPHY>, <&cru PCLK_USBPHY>;
+			clock-names = "phyclk", "pclk";
+			resets = <&cru SRST_USBPHY_POR>, <&cru SRST_P_USBPHY>;
+			reset-names = "phy", "apb";
+			rockchip,usbgrf = <&grf>;
+			#clock-cells = <0>;
+			clock-output-names = "usb480m_phy";
+			status = "disabled";
+
+			u2phy_otg: otg-port {
+				interrupts = <GIC_SPI 58 IRQ_TYPE_LEVEL_HIGH>,
+						<GIC_SPI 59 IRQ_TYPE_LEVEL_HIGH>,
+						<GIC_SPI 60 IRQ_TYPE_LEVEL_HIGH>,
+						<GIC_SPI 61 IRQ_TYPE_LEVEL_HIGH>;
+				interrupt-names = "otg-bvalid", "otg-id",
+						"linestate", "disconnect";
+				#phy-cells = <0>;
+				status = "disabled";
+			};
+		};
+
 		uart0: serial at ff4a0000 {
 			compatible = "rockchip,rv1106-uart", "snps,dw-apb-uart";
 			reg = <0xff4a0000 0x100>;
@@ -378,6 +402,30 @@ sfc: spi at ffac0000 {
 			#size-cells = <0>;
 			status = "disabled";
 		};
+
+		usbdrd_dwc3: usb at ffb00000 {
+			compatible = "rockchip,rv1106-dwc3", "snps,dwc3";
+			reg = <0xffb00000 0x100000>;
+			interrupts = <GIC_SPI 54 IRQ_TYPE_LEVEL_HIGH>;
+			clocks = <&cru CLK_REF_USBOTG>, <&cru ACLK_USBOTG>,
+				<&cru CLK_UTMI_USBOTG>;
+			clock-names = "ref_clk", "bus_clk", "utmi";
+			resets = <&cru SRST_A_USBOTG>;
+			dr_mode = "otg";
+			maximum-speed = "high-speed";
+			phys = <&u2phy_otg>;
+			phy-names = "usb2-phy";
+			phy_type = "utmi_wide";
+			snps,dis_enblslpm_quirk;
+			snps,dis-u2-freeclk-exists-quirk;
+			snps,dis_u2_susphy_quirk;
+			snps,dis-del-phy-power-chg-quirk;
+			snps,dis-tx-ipgap-linecheck-quirk;
+			snps,usb2-gadget-lpm-disable;
+			snps,usb2-lpm-disable;
+			snps,parkmode-disable-hs-quirk;
+			status = "disabled";
+		};
 	};
 };
 
-- 
2.47.3