[PATCH v5 0/2] PCI: mediatek-gen3: Add 2-lanes mode support + clock

[Benjamin Larsson]

On 09/08/2026 14:12, Christian Marangi (Ansuel) wrote:
> Il giorno ven 7 ago 2026 alle ore 17:21 Bjorn Helgaas
> <helgaas at kernel.org> ha scritto:
>>
>> On Fri, Aug 07, 2026 at 11:24:09AM +0800, Chen-Yu Tsai wrote:
>>> On Fri, Aug 7, 2026 at 12:53 AM Christian Marangi <ansuelsmth at gmail.com> wrote:
>>>> This small series introduce support for 2-lanes mode for Airoha AN7581
>>>
>>> Just a nitpick, but I would probably name this something else, like
>>> "cross-controller lane-bonding mode" or "lane stealing"? PCIe already
>>> has 2x lanes as a standard feature, so this naming is a bit confusing.
>>> It's not like dual-LVDS display in which LVDS is only a single lane.
>>
>> I suggested the "2-lane" and "x2" terminology because I assumed the
>> result is what the PCIe spec would describe as a "x2 Link" consisting
>> of two Lanes.
>>
>> If that's not the case, maybe "cross-controller lane-bonding mode" or
>> "lane stealing" would be more accurate, but I don't know what those
>> mean, so if we use them I would also like to know what the result
>> looks like in standard PCIe terms.
>>
> 
> Mhhh I don't really like the term lane stealing. Also cross-controller
> lane-bonding
> might be a first. Even if correct it would complicate identification
> of the feature
> that at the end of the day configures the HW to provide a 2 lanes PCIe.
> 
> Consider that in such mode, the other PCIe controller gets disabled (this is
> handled in DT) so it's effectively enabling the standard PCIe 2x lanes
> and apply the HW configuration for it.
> 
>>>> SoC. This is needed for correctly functionality of Eagle WiFi Card
>>>> normally attached to this SoC that require a 2-line PCIe card to
>>>> correctly work (and give the proper performance)
>>>>
>>>> The first 2 patch address a limitation of the PCIe implementation
>>>> where the PERSTOUT reset were indirectly asserted and deasserted
>>>> all at the same time (for all the 3 PCIe card) with PCIe
>>>> enable and disable.
>>>> The 2 patch address this and introduce correct reset to control
>>>> reset line for the relevant PCIe line.
>>>>
>>>> The last 2 patch add additional logic and support to assert
>>>> and deassert the PERSTOUT and also apply the required configuration
>>>> for 2-lanes mode.
>>>>
>>>> 2-lanes mode is implemented in DT by adding the required property
>>>> and by defining the "num-lanes" to 2.
> 

Hi. Isnt this just pcie bifurcation?

Logically bifurcation would need to be disabled when using 2 lanes in 
one slot and enabled when 2 lanes are split between 2 pcie slots.

But I'm not really sure what value a bifurcation property would add. 
Isnt the current schema enough?

The mt7987 will need the same logic as it can also bifurcate one pcie slot.

MvH
Benjamin Larsson