[RFC PATCH v5 v5 8/8] arm64: dts: rockchip: rk3576-rock-4d: enable NPU

[Jiaxing Hu]

Enable rknn_core_0 and its IOMMU on the Radxa ROCK 4D and supply the
core from vdd_npu_s0.

The supply is marked always-on because the NPU power domains are what
gate the block here, and dropping the rail underneath them takes an
async SError on the next power-on rather than a clean retry. Only
rknn_core_0 is enabled: the driver binds one core per node and the
second core is left to whoever can test it.

Signed-off-by: Jiaxing Hu <gahing at gahingwoo.com>
---
 arch/arm64/boot/dts/rockchip/rk3576-rock-4d.dts | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/rk3576-rock-4d.dts b/arch/arm64/boot/dts/rockchip/rk3576-rock-4d.dts
index 272af1012..965e0906b 100644
--- a/arch/arm64/boot/dts/rockchip/rk3576-rock-4d.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3576-rock-4d.dts
@@ -442,6 +442,7 @@ regulator-state-mem {
 			};
 
 			vdd_npu_s0: dcdc-reg2 {
+				regulator-always-on;
 				regulator-boot-on;
 				regulator-enable-ramp-delay = <400>;
 				regulator-min-microvolt = <550000>;
@@ -869,3 +870,12 @@ vp0_out_hdmi: endpoint at ROCKCHIP_VOP2_EP_HDMI0 {
 		remote-endpoint = <&hdmi_in_vp0>;
 	};
 };
+
+&rknn_core_0 {
+	npu-supply = <&vdd_npu_s0>;
+	status = "okay";
+};
+
+&rknn_mmu_0 {
+	status = "okay";
+};
-- 
2.43.0