[PATCH 1/1] arm64: dts: st: Add I/O sync to eth1 pinctrl in stm32mp25-pinctrl.dtsi

[Alexandre TORGUE]

Hi Christophe,

On 7/30/26 17:59, Christophe Roullier wrote:
> On board stm32mp235f-dk, stm32mp257f-dk the propagation
> delay between eth1 and the external PHY requires a compensation to
> guarantee that no packet get lost in all the working conditions.
> 
> Add I/O synchronization properties in pinctrl on all the RGMII
> data pins, activating re-sampling on both edges of the clock.
> 
> Co-developed-by: Christophe Roullier <christophe.roullier at foss.st.com>
> Signed-off-by: Christophe Roullier <christophe.roullier at foss.st.com>
> Signed-off-by: Antonio Borneo <antonio.borneo at foss.st.com>

I think you co-developped this commit with Antonio (not with yourselef). So maybe that the correct order would be:
- co-dev...: antonio
- signed off antonio:
- then your sign off

regards
Alex


> ---
>   arch/arm64/boot/dts/st/stm32mp25-pinctrl.dtsi | 2 ++
>   1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/st/stm32mp25-pinctrl.dtsi b/arch/arm64/boot/dts/st/stm32mp25-pinctrl.dtsi
> index 456ece7f8ebc..4fcfc4528c5e 100644
> --- a/arch/arm64/boot/dts/st/stm32mp25-pinctrl.dtsi
> +++ b/arch/arm64/boot/dts/st/stm32mp25-pinctrl.dtsi
> @@ -95,6 +95,7 @@ pins1 {
>   			bias-disable;
>   			drive-push-pull;
>   			slew-rate = <3>;
> +			st,io-sync = "data on both edges";
>   		};
>   		pins2 {
>   			pinmux = <STM32_PINMUX('H', 9, AF10)>, /* ETH_RGMII_CLK125 */
> @@ -112,6 +113,7 @@ pins3 {
>   				 <STM32_PINMUX('H', 13, AF10)>, /* ETH_RGMII_RXD3 */
>   				 <STM32_PINMUX('A', 11, AF10)>; /* ETH_RGMII_RX_CTL */
>   			bias-disable;
> +			st,io-sync = "data on both edges";
>   		};
>   		pins4 {
>   			pinmux = <STM32_PINMUX('A', 14, AF10)>; /* ETH_RGMII_RX_CLK */