[PATCH v21 12/13] arm64: dts: qcom: Add psci reboot-modes for monaco boards

[Shivendra Pratap]

Add PSCI SYSTEM_RESET2 reboot-modes for monaco-evk and
qcs8300-ride for use by the psci-reboot-mode driver.

The following modes are defined:
- bootloader: reboot into fastboot mode for fastboot flashing.
- edl: reboot into emergency download mode for image loading via
  the Firehose protocol.

Support for these modes is firmware dependent.

Signed-off-by: Shivendra Pratap <shivendra.pratap at oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/monaco-evk.dts   | 7 +++++++
 arch/arm64/boot/dts/qcom/monaco.dtsi      | 2 +-
 arch/arm64/boot/dts/qcom/qcs8300-ride.dts | 7 +++++++
 3 files changed, 15 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/monaco-evk.dts b/arch/arm64/boot/dts/qcom/monaco-evk.dts
index 9d17ef7d2caf130564efc2d0159ac0de39126e80..df668dbf2bc60175c36cabfa310aff625647899e 100644
--- a/arch/arm64/boot/dts/qcom/monaco-evk.dts
+++ b/arch/arm64/boot/dts/qcom/monaco-evk.dts
@@ -661,6 +661,13 @@ usb2_id: usb2-id-state {
 	};
 };
 
+&psci {
+	reboot-mode {
+		mode-bootloader = <0x80010001 0x2>;
+		mode-edl = <0x80000000 0x1>;
+	};
+};
+
 &qup_i2c0_data_clk {
 	drive-strength = <2>;
 	bias-pull-up;
diff --git a/arch/arm64/boot/dts/qcom/monaco.dtsi b/arch/arm64/boot/dts/qcom/monaco.dtsi
index 7b1d57460f1e6953acc7fa06d22a1f83ab24edb0..da675f7a8f2d83f3598a6a7ad71a99206213d03c 100644
--- a/arch/arm64/boot/dts/qcom/monaco.dtsi
+++ b/arch/arm64/boot/dts/qcom/monaco.dtsi
@@ -674,7 +674,7 @@ pmu-a78 {
 		interrupts = <GIC_PPI 7 IRQ_TYPE_LEVEL_LOW>;
 	};
 
-	psci {
+	psci: psci {
 		compatible = "arm,psci-1.0";
 		method = "smc";
 
diff --git a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
index e9a8553a8d821ca88a38ac59a78625707850bb5d..3ab5ae3124ed5314f04202b6b247fbbbef665053 100644
--- a/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
+++ b/arch/arm64/boot/dts/qcom/qcs8300-ride.dts
@@ -678,6 +678,13 @@ &mdss_dsi0_out {
 	remote-endpoint = <&dsi2dp_bridge_in>;
 };
 
+&psci {
+	reboot-mode {
+		mode-bootloader = <0x80010001 0x2>;
+		mode-edl = <0x80000000 0x1>;
+	};
+};
+
 &qupv3_id_0 {
 	status = "okay";
 };

-- 
2.34.1