[PATCH v2 3/4] gpio: realtek: Add driver for Realtek DHC RTD1625 SoC

Wed Apr 8 00:31:29 PDT 2026

On Wed, 8 Apr 2026 04:52:42 +0200, Yu-Chun Lin <eleanor.lin at realtek.com> said:
> From: Tzuyi Chang <tychang at realtek.com>
>
> Add support for the GPIO controller found on Realtek DHC RTD1625 SoCs.
>
> Unlike the existing Realtek GPIO driver (drivers/gpio/gpio-rtd.c),
> which manages pins via shared bank registers, the RTD1625 introduces
> a per-pin register architecture. Each GPIO line now has its own
> dedicated 32-bit control register to manage configuration independently,
> including direction, output value, input value, interrupt enable, and
> debounce. Therefore, this distinct hardware design requires a separate
> driver.
>
> Reviewed-by: Linus Walleij <linusw at kernel.org>
> Signed-off-by: Tzuyi Chang <tychang at realtek.com>
> Signed-off-by: Yu-Chun Lin <eleanor.lin at realtek.com>
> ---
> Changes in v2:
> - Remove "default y".
> - Add base_offset member to struct rtd1625_gpio_info to handle merged regions.
> ---
>  drivers/gpio/Kconfig        |  11 +
>  drivers/gpio/Makefile       |   1 +
>  drivers/gpio/gpio-rtd1625.c | 584 ++++++++++++++++++++++++++++++++++++
>  3 files changed, 596 insertions(+)
>  create mode 100644 drivers/gpio/gpio-rtd1625.c
>
> diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
> index 5ee11a889867..281549ad72ac 100644
> --- a/drivers/gpio/Kconfig
> +++ b/drivers/gpio/Kconfig
> @@ -638,6 +638,17 @@ config GPIO_RTD
>  	  Say yes here to support GPIO functionality and GPIO interrupt on
>  	  Realtek DHC SoCs.
>
> +config GPIO_RTD1625
> +	tristate "Realtek DHC RTD1625 GPIO support"
> +	depends on ARCH_REALTEK || COMPILE_TEST
> +	select GPIOLIB_IRQCHIP
> +	help
> +	  This option enables support for the GPIO controller on Realtek
> +	  DHC (Digital Home Center) RTD1625 SoC.
> +
> +	  Say yes here to support both basic GPIO line functionality
> +	  and GPIO interrupt handling capabilities for this platform.
> +
>  config GPIO_SAMA5D2_PIOBU
>  	tristate "SAMA5D2 PIOBU GPIO support"
>  	depends on MFD_SYSCON
> diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
> index c05f7d795c43..c95ba218d53a 100644
> --- a/drivers/gpio/Makefile
> +++ b/drivers/gpio/Makefile
> @@ -159,6 +159,7 @@ obj-$(CONFIG_GPIO_REALTEK_OTTO)		+= gpio-realtek-otto.o
>  obj-$(CONFIG_GPIO_REG)			+= gpio-reg.o
>  obj-$(CONFIG_GPIO_ROCKCHIP)	+= gpio-rockchip.o
>  obj-$(CONFIG_GPIO_RTD)			+= gpio-rtd.o
> +obj-$(CONFIG_GPIO_RTD1625)		+= gpio-rtd1625.o
>  obj-$(CONFIG_ARCH_SA1100)		+= gpio-sa1100.o
>  obj-$(CONFIG_GPIO_SAMA5D2_PIOBU)	+= gpio-sama5d2-piobu.o
>  obj-$(CONFIG_GPIO_SCH311X)		+= gpio-sch311x.o
> diff --git a/drivers/gpio/gpio-rtd1625.c b/drivers/gpio/gpio-rtd1625.c
> new file mode 100644
> index 000000000000..bcc1bbb115fa
> --- /dev/null
> +++ b/drivers/gpio/gpio-rtd1625.c
> @@ -0,0 +1,584 @@
> +// SPDX-License-Identifier: GPL-2.0-or-later
> +/*
> + * Realtek DHC RTD1625 gpio driver
> + *
> + * Copyright (c) 2023 Realtek Semiconductor Corp.

No modifications since 2023?

> + */
> +
> +#include <linux/bitfield.h>
> +#include <linux/bitops.h>
> +#include <linux/gpio/driver.h>
> +#include <linux/interrupt.h>
> +#include <linux/irqchip.h>
> +#include <linux/irqchip/chained_irq.h>
> +#include <linux/irqdomain.h>
> +#include <linux/module.h>
> +#include <linux/platform_device.h>
> +#include <linux/property.h>
> +#include <linux/spinlock.h>
> +#include <linux/types.h>
> +
> +#define RTD1625_GPIO_DIR BIT(0)
> +#define RTD1625_GPIO_OUT BIT(2)
> +#define RTD1625_GPIO_IN BIT(4)
> +#define RTD1625_GPIO_EDGE_INT_DP BIT(6)
> +#define RTD1625_GPIO_EDGE_INT_EN BIT(8)
> +#define RTD1625_GPIO_LEVEL_INT_EN BIT(16)
> +#define RTD1625_GPIO_LEVEL_INT_DP BIT(18)
> +#define RTD1625_GPIO_DEBOUNCE GENMASK(30, 28)
> +#define RTD1625_GPIO_DEBOUNCE_WREN BIT(31)
> +
> +#define RTD1625_GPIO_WREN(x) ((x) << 1)
> +
> +/* Write-enable masks for all GPIO configs and reserved hardware bits */
> +#define RTD1625_ISO_GPIO_WREN_ALL 0x8000aa8a
> +#define RTD1625_ISOM_GPIO_WREN_ALL 0x800aaa8a
> +
> +#define RTD1625_GPIO_DEBOUNCE_1US 0
> +#define RTD1625_GPIO_DEBOUNCE_10US 1
> +#define RTD1625_GPIO_DEBOUNCE_100US 2
> +#define RTD1625_GPIO_DEBOUNCE_1MS 3
> +#define RTD1625_GPIO_DEBOUNCE_10MS 4
> +#define RTD1625_GPIO_DEBOUNCE_20MS 5
> +#define RTD1625_GPIO_DEBOUNCE_30MS 6
> +#define RTD1625_GPIO_DEBOUNCE_50MS 7
> +
> +#define GPIO_CONTROL(gpio) ((gpio) * 4)
> +
> +/**
> + * struct rtd1625_gpio_info - Specific GPIO register information
> + * @num_gpios: The number of GPIOs
> + * @irq_type_support: Supported IRQ types
> + * @gpa_offset: Offset for GPIO assert interrupt status registers
> + * @gpda_offset: Offset for GPIO deassert interrupt status registers
> + * @level_offset: Offset of level interrupt status register
> + * @write_en_all: Write-enable mask for all configurable bits
> + */
> +struct rtd1625_gpio_info {
> +	unsigned int	num_gpios;
> +	unsigned int	irq_type_support;
> +	unsigned int	base_offset;
> +	unsigned int	gpa_offset;
> +	unsigned int	gpda_offset;
> +	unsigned int	level_offset;
> +	unsigned int	write_en_all;
> +};

Please remove the tabs in the above struct.

> +
> +struct rtd1625_gpio {
> +	struct gpio_chip		gpio_chip;
> +	const struct rtd1625_gpio_info	*info;
> +	void __iomem			*base;
> +	void __iomem			*irq_base;
> +	unsigned int			irqs[3];
> +	raw_spinlock_t			lock;
> +	unsigned int			*save_regs;
> +};

I'd also personally remove these tabs here but won't die on that hill.

> +
> +static unsigned int rtd1625_gpio_gpa_offset(struct rtd1625_gpio *data, unsigned int offset)
> +{
> +	return data->info->gpa_offset + ((offset / 32) * 4);
> +}
> +
> +static unsigned int rtd1625_gpio_gpda_offset(struct rtd1625_gpio *data, unsigned int offset)
> +{
> +	return data->info->gpda_offset + ((offset / 32) * 4);
> +}
> +
> +static unsigned int rtd1625_gpio_level_offset(struct rtd1625_gpio *data, unsigned int offset)
> +{
> +	return data->info->level_offset + ((offset / 32) * 4);
> +}

Looking at these, I'm under the impression that this driver could quite easily
be converted to using gpio-mmio or even gpio-regmap with an MMIO regmap, have
you looked into it by any chance?

Bart