[PATCH v7 2/8] arm64: dts: qcom: qcs6490-rb3gen2: Add TC9563 PCIe switch node

[Krishna Chaitanya Chundru]

Add a node for the TC9563 PCIe switch, which has three downstream ports.
Two embedded Ethernet devices are present on one of the downstream ports.
As all these ports are present in the node represent the downstream
ports and embedded endpoints.

Power to the TC9563 is supplied through two LDO regulators, controlled by
two GPIOs, which are added as fixed regulators. Configure the TC9563
through I2C.

Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru at oss.qualcomm.com>
Reviewed-by: Bjorn Andersson <andersson at kernel.org>
Acked-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts | 128 +++++++++++++++++++++++++++
 arch/arm64/boot/dts/qcom/sc7280.dtsi         |   2 +-
 2 files changed, 129 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
index 18cea8812001421456dc85547c3c711e2c42182a..c8308de1116e07f83f345faca0f29b9da3c4f474 100644
--- a/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
+++ b/arch/arm64/boot/dts/qcom/qcs6490-rb3gen2.dts
@@ -262,6 +262,30 @@ vph_pwr: vph-pwr-regulator {
 		regulator-max-microvolt = <3700000>;
 	};
 
+	vdd_ntn_0p9: regulator-vdd-ntn-0p9 {
+		compatible = "regulator-fixed";
+		regulator-name = "VDD_NTN_0P9";
+		gpio = <&pm8350c_gpios 2 GPIO_ACTIVE_HIGH>;
+		regulator-min-microvolt = <899400>;
+		regulator-max-microvolt = <899400>;
+		enable-active-high;
+		pinctrl-0 = <&ntn_0p9_en>;
+		pinctrl-names = "default";
+		regulator-enable-ramp-delay = <4300>;
+	};
+
+	vdd_ntn_1p8: regulator-vdd-ntn-1p8 {
+		compatible = "regulator-fixed";
+		regulator-name = "VDD_NTN_1P8";
+		gpio = <&pm8350c_gpios 3 GPIO_ACTIVE_HIGH>;
+		regulator-min-microvolt = <1800000>;
+		regulator-max-microvolt = <1800000>;
+		enable-active-high;
+		pinctrl-0 = <&ntn_1p8_en>;
+		pinctrl-names = "default";
+		regulator-enable-ramp-delay = <10000>;
+	};
+
 	wcn6750-pmu {
 		compatible = "qcom,wcn6750-pmu";
 		pinctrl-0 = <&bt_en>;
@@ -843,6 +867,78 @@ &pcie1_phy {
 	status = "okay";
 };
 
+&pcie1_port0 {
+	pcie at 0,0 {
+		compatible = "pci1179,0623";
+		reg = <0x10000 0x0 0x0 0x0 0x0>;
+		#address-cells = <3>;
+		#size-cells = <2>;
+
+		device_type = "pci";
+		ranges;
+		bus-range = <0x2 0xff>;
+
+		vddc-supply = <&vdd_ntn_0p9>;
+		vdd18-supply = <&vdd_ntn_1p8>;
+		vdd09-supply = <&vdd_ntn_0p9>;
+		vddio1-supply = <&vdd_ntn_1p8>;
+		vddio2-supply = <&vdd_ntn_1p8>;
+		vddio18-supply = <&vdd_ntn_1p8>;
+
+		i2c-parent = <&i2c0 0x77>;
+
+		reset-gpios = <&pm8350c_gpios 1 GPIO_ACTIVE_LOW>;
+
+		pinctrl-0 = <&tc9563_rsex_n>;
+		pinctrl-names = "default";
+
+		pcie at 1,0 {
+			reg = <0x20800 0x0 0x0 0x0 0x0>;
+			#address-cells = <3>;
+			#size-cells = <2>;
+
+			device_type = "pci";
+			ranges;
+			bus-range = <0x3 0xff>;
+		};
+
+		pcie at 2,0 {
+			reg = <0x21000 0x0 0x0 0x0 0x0>;
+			#address-cells = <3>;
+			#size-cells = <2>;
+
+			device_type = "pci";
+			ranges;
+			bus-range = <0x4 0xff>;
+		};
+
+		pcie at 3,0 {
+			reg = <0x21800 0x0 0x0 0x0 0x0>;
+			#address-cells = <3>;
+			#size-cells = <2>;
+			device_type = "pci";
+			ranges;
+			bus-range = <0x5 0xff>;
+
+			pci at 0,0 {
+				reg = <0x50000 0x0 0x0 0x0 0x0>;
+				#address-cells = <3>;
+				#size-cells = <2>;
+				device_type = "pci";
+				ranges;
+			};
+
+			pci at 0,1 {
+				reg = <0x50100 0x0 0x0 0x0 0x0>;
+				#address-cells = <3>;
+				#size-cells = <2>;
+				device_type = "pci";
+				ranges;
+			};
+		};
+	};
+};
+
 &pm7325_gpios {
 	kypd_vol_up_n: kypd-vol-up-n-state {
 		pins = "gpio6";
@@ -1119,6 +1215,38 @@ right_spkr: speaker at 0,2 {
 	};
 };
 
+&pm8350c_gpios {
+	ntn_0p9_en: ntn-0p9-en-state {
+		pins = "gpio2";
+		function = "normal";
+
+		bias-disable;
+		input-disable;
+		output-enable;
+		power-source = <0>;
+	};
+
+	ntn_1p8_en: ntn-1p8-en-state {
+		pins = "gpio3";
+		function = "normal";
+
+		bias-disable;
+		input-disable;
+		output-enable;
+		power-source = <0>;
+	};
+
+	tc9563_rsex_n: tc9563-resx-state {
+		pins = "gpio1";
+		function = "normal";
+
+		bias-disable;
+		input-disable;
+		output-enable;
+		power-source = <0>;
+	};
+};
+
 &tlmm {
 	gpio-reserved-ranges = <32 2>, /* ADSP */
 			       <48 4>; /* NFC */
diff --git a/arch/arm64/boot/dts/qcom/sc7280.dtsi b/arch/arm64/boot/dts/qcom/sc7280.dtsi
index 4b04dea57ec8cc652e37f1d93c410404adaadd5d..23cf2c8c72b0bab67467e4b60cd57a3e658efa68 100644
--- a/arch/arm64/boot/dts/qcom/sc7280.dtsi
+++ b/arch/arm64/boot/dts/qcom/sc7280.dtsi
@@ -2424,7 +2424,7 @@ pcie1: pcie at 1c08000 {
 
 			status = "disabled";
 
-			pcie at 0 {
+			pcie1_port0: pcie at 0 {
 				device_type = "pci";
 				reg = <0x0 0x0 0x0 0x0 0x0>;
 				bus-range = <0x01 0xff>;

-- 
2.34.1