[PATCH v3 0/2] Add devicetree for NXP i.MX93 FRDM board

[Fabian Pflug]

I could not test all features of the board, therefore a lot of stuff is
omitted from the devicetree. but this is enough to have the board boot
via eMMC or SD-Card, debug via debug USB connector and have a network
connection.

The FRDM i.MX 93 development board is a low-cost and compact development
board featuring the i.MX93 applications processor.

It features:
- Dual Cortex-A55
- 2 GB LPDDR4X / LPDDR4
- 32 GB eMMC5.1
- MicroSD slot
- GbE RJ45 x 2
- USB2.0 1x Type C, 1x Type A

This file is based upon the one provided by nxp in their own kernel and
yocto meta layer for the device, but adapted for mainline.

Signed-off-by: Fabian Pflug <f.pflug at pengutronix.de>
---
Changes in v3:
- Add Signed-off for original NXP contributors.
- Fixed whitespace errors (Thanks Francesco Valla)
- Added mu1 with status okay (Thanks Francesco Valla)
- Removed address cells from lpi2c3 (Thanks Frank Li)
- Configure pin for watchdog (Thanks Peng Fan)
- Updated regulator config
- Configure i2c0
- Link to v2: https://lore.kernel.org/r/20250526-fpg-nxp-imx93-frdm-v2-0-e5ad0efaec33@pengutronix.de

Changes in v2:
- 1/2: remove CAN node, as it has not been tested.
- 1/2: ran dt-format (Thanks Frank Li)
	But also reordered some nodes afterwards again to have
	regulator-min before regulator-max, have the pinmux at the end
	of the file, and have the regulator-name as the first node
	inside the regulators.
	Re-added comments, that were deleted.
- 1/2: changes subjet to ar64:dts (Thanks Fabio Estevan)
- 1/2: removed reg_vdd_12v (Tanks Fabio Estevan)
- 1/2: added aliases for rtc, emmc, serial (Thanks Fabio Estevan)
- reordered the series to have documentation before dts. (Thanks
  Krzystof Kozlowski)
- Link to v1: https://lore.kernel.org/r/20250523-fpg-nxp-imx93-frdm-v1-0-546b2d342855@pengutronix.de

---
Fabian Pflug (2):
      dt-bindings: arm: fsl: add i.MX93 11x11 FRDM board
      arm64: dts: freescale: add support for NXP i.MX93 FRDM

 Documentation/devicetree/bindings/arm/fsl.yaml     |   1 +
 arch/arm64/boot/dts/freescale/Makefile             |   1 +
 arch/arm64/boot/dts/freescale/imx93-11x11-frdm.dts | 658 +++++++++++++++++++++
 3 files changed, 660 insertions(+)
---
base-commit: 552c50713f273b494ac6c77052032a49bc9255e2
change-id: 20250523-fpg-nxp-imx93-frdm-5cc180a1fda9

Best regards,
-- 
Fabian Pflug <f.pflug at pengutronix.de>