[PATCH v4 23/31] clk: at91: sama5d2: switch to parent_hw and parent_data

[Claudiu Beznea]

Hi, Ryan,

On 9/19/25 00:16, Ryan.Wanner at microchip.com wrote:
> From: Claudiu Beznea <claudiu.beznea at tuxon.dev>
> 
> Switch SAMA5D2 clocks to use parent_hw and parent_data. Having
> parent_hw instead of parent names improves to clock registration

But only a small part of conversion uses parent_hw. Could you please
improve this description? Same for the other patches.

> speed and re-parenting.
> 
> Signed-off-by: Claudiu Beznea <claudiu.beznea at tuxon.dev>
> [ryan.wanner at microchip.com: Adjust commit message.]
> Signed-off-by: Ryan Wanner <Ryan.Wanner at microchip.com>
> ---
>  drivers/clk/at91/sama5d2.c | 157 ++++++++++++++++++++-----------------
>  1 file changed, 85 insertions(+), 72 deletions(-)
> 
> diff --git a/drivers/clk/at91/sama5d2.c b/drivers/clk/at91/sama5d2.c
> index f5d6c7a96cf2..231cec1f80e1 100644
> --- a/drivers/clk/at91/sama5d2.c
> +++ b/drivers/clk/at91/sama5d2.c
> @@ -37,9 +37,9 @@ static const struct clk_pcr_layout sama5d2_pcr_layout = {
>  	.pid_mask = GENMASK(6, 0),
>  };
>  
> -static const struct {
> +static struct {
>  	char *n;
> -	char *p;
> +	struct clk_hw *parent_hw;
>  	unsigned long flags;
>  	u8 id;
>  } sama5d2_systemck[] = {
> @@ -47,14 +47,14 @@ static const struct {
>  	 * ddrck feeds DDR controller and is enabled by bootloader thus we need
>  	 * to keep it enabled in case there is no Linux consumer for it.
>  	 */
> -	{ .n = "ddrck", .p = "masterck_div", .id = 2, .flags = CLK_IS_CRITICAL },
> -	{ .n = "lcdck", .p = "masterck_div", .id = 3 },
> -	{ .n = "uhpck", .p = "usbck",        .id = 6 },
> -	{ .n = "udpck", .p = "usbck",        .id = 7 },
> -	{ .n = "pck0",  .p = "prog0",        .id = 8 },
> -	{ .n = "pck1",  .p = "prog1",        .id = 9 },
> -	{ .n = "pck2",  .p = "prog2",        .id = 10 },
> -	{ .n = "iscck", .p = "masterck_div", .id = 18 },
> +	{ .n = "ddrck", .id = 2, .flags = CLK_IS_CRITICAL },
> +	{ .n = "lcdck", .id = 3 },
> +	{ .n = "uhpck", .id = 6 },
> +	{ .n = "udpck", .id = 7 },
> +	{ .n = "pck0",  .id = 8 },
> +	{ .n = "pck1",  .id = 9 },
> +	{ .n = "pck2",  .id = 10 },
> +	{ .n = "iscck", .id = 18 },
>  };
>  
>  static const struct {
> @@ -164,12 +164,12 @@ static const struct clk_programmable_layout sama5d2_programmable_layout = {
>  
>  static void __init sama5d2_pmc_setup(struct device_node *np)
>  {
> +	struct clk_hw *hw, *audio_fracck_hw, *usbck_hw, *main_rc_hw, *main_osc_hw;
> +	const char *slow_clk_name, *main_xtal_name;

Please specify in the commit description why did you changed the variable
names or keep them as before. Valid for the other patches in this series
where this pattern appears.