[PATCH v1 2/3] PCI: j721e: Use devm_clk_get_optional_enabled() to get the clock

[Anand Moon]

Use devm_clk_get_optional_enabled() helper instead of calling
devm_clk_get_optional() and then clk_prepare_enable(). It simplifies
the error handling and makes the code more compact. This changes removes
the unnecessary clk variable and assigns the result of the
devm_clk_get_optional_enabled() call directly to pcie->refclk.
This makes the code more concise and readable without changing the
behavior.

Cc: Siddharth Vadapalli <s-vadapalli at ti.com>
Signed-off-by: Anand Moon <linux.amoon at gmail.com>
---
v1: Drop explicit clk_disable_unprepare — handled by devm_clk_get_optional_enabled
    Since devm_clk_get_optional_enabled internally manages clk_prepare_enable and
    clk_disable_unprepare as part of its lifecycle, the explicit call to
    clk_disable_unprepare is redundant and can be safely removed.
---
 drivers/pci/controller/cadence/pci-j721e.c | 14 ++------------
 1 file changed, 2 insertions(+), 12 deletions(-)

diff --git a/drivers/pci/controller/cadence/pci-j721e.c b/drivers/pci/controller/cadence/pci-j721e.c
index 9c7bfa77a66e..ed8e182f0772 100644
--- a/drivers/pci/controller/cadence/pci-j721e.c
+++ b/drivers/pci/controller/cadence/pci-j721e.c
@@ -479,7 +479,6 @@ static int j721e_pcie_probe(struct platform_device *pdev)
 	struct cdns_pcie_ep *ep = NULL;
 	struct gpio_desc *gpiod;
 	void __iomem *base;
-	struct clk *clk;
 	u32 num_lanes;
 	u32 mode;
 	int ret;
@@ -603,18 +602,11 @@ static int j721e_pcie_probe(struct platform_device *pdev)
 			goto err_get_sync;
 		}
 
-		clk = devm_clk_get_optional(dev, "pcie_refclk");
-		if (IS_ERR(clk)) {
-			ret = dev_err_probe(dev, PTR_ERR(clk), "failed to get pcie_refclk\n");
-			goto err_pcie_setup;
-		}
-
-		ret = clk_prepare_enable(clk);
-		if (ret) {
+		pcie->refclk = devm_clk_get_optional_enabled(dev, "pcie_refclk");
+		if (IS_ERR(pcie->refclk)) {
 			ret = dev_err_probe(dev, ret, "failed to enable pcie_refclk\n");
 			goto err_pcie_setup;
 		}
-		pcie->refclk = clk;
 
 		/*
 		 * Section 2.2 of the PCI Express Card Electromechanical
@@ -630,7 +622,6 @@ static int j721e_pcie_probe(struct platform_device *pdev)
 
 		ret = cdns_pcie_host_setup(rc);
 		if (ret < 0) {
-			clk_disable_unprepare(pcie->refclk);
 			goto err_pcie_setup;
 		}
 
@@ -679,7 +670,6 @@ static void j721e_pcie_remove(struct platform_device *pdev)
 
 	gpiod_set_value_cansleep(pcie->reset_gpio, 0);
 
-	clk_disable_unprepare(pcie->refclk);
 	cdns_pcie_disable_phy(cdns_pcie);
 	j721e_pcie_disable_link_irq(pcie);
 	pm_runtime_put(dev);
-- 
2.50.1