[PATCH v5 3/8] phy: rockchip: phy-rockchip-typec: Add typec_mux/typec_switch support

[Chaoyi Chen]

On 10/12/2025 12:57 AM, Dmitry Baryshkov wrote:

> On Sat, Oct 11, 2025 at 11:32:28AM +0800, Chaoyi Chen wrote:
>> From: Chaoyi Chen <chaoyi.chen at rock-chips.com>
>>
>> This patch add support for Type-C Port Controller Manager. Each PHY
>> will register typec_mux and typec_switch when external Type-C
>> controller is present. Type-C events are handled by TCPM without
>> extcon.
>>
>> The extcon device should still be supported.
>>
>> Signed-off-by: Chaoyi Chen <chaoyi.chen at rock-chips.com>
>> ---
>>
>> (no changes since v5)
>>
>> Changes in v4:
>> - Remove notify DP HPD state by USB/DP PHY.
>>
>> (no changes since v3)
>>
>> Changes in v2:
>> - Fix compile error when CONFIG_TYPEC is not enabled.
>> - Notify DP HPD state by USB/DP PHY.
>>
>>   drivers/phy/rockchip/phy-rockchip-typec.c | 365 +++++++++++++++++++++-
>>   1 file changed, 349 insertions(+), 16 deletions(-)
>>
>> @@ -850,6 +998,72 @@ static int tcphy_get_mode(struct rockchip_typec_phy *tcphy)
>>   	return mode;
>>   }
>>   
>> +#if IS_ENABLED(CONFIG_TYPEC)
>> +static int tcphy_orien_sw_set(struct typec_switch_dev *sw,
>> +			      enum typec_orientation orien)
>> +{
>> +	struct rockchip_typec_phy *tcphy = typec_switch_get_drvdata(sw);
>> +
>> +	mutex_lock(&tcphy->lock);
>> +
>> +	if (orien == TYPEC_ORIENTATION_NONE) {
>> +		tcphy->new_mode = MODE_DISCONNECT;
>> +		goto unlock_ret;
>> +	}
>> +
>> +	tcphy->flip = (orien == TYPEC_ORIENTATION_REVERSE) ? true : false;
>> +	tcphy->new_mode = MODE_DFP_USB;
> Carrying over unanswered(!) comment from the previous series:
>
> I don't think it is correct. Orientation defines only the cable (plug)
> orientation. You should be getting the mux events for the mode
> selection.

Sorry for that, I forgot to modify this part. Will fix in v6.


>
>> +
>> +unlock_ret:
>> +	mutex_unlock(&tcphy->lock);
>> +	return 0;
>> +}
>> +
>> +static void udphy_orien_switch_unregister(void *data)
>> +{
>> +	struct rockchip_typec_phy *tcphy = data;
>> +
>> +	typec_switch_unregister(tcphy->sw);
>> +}
>> +
>> @@ -1037,6 +1251,89 @@ static const struct phy_ops rockchip_dp_phy_ops = {
>>   	.owner		= THIS_MODULE,
>>   };
>>   
>> +#if IS_ENABLED(CONFIG_TYPEC)
>> +static int tcphy_typec_mux_set(struct typec_mux_dev *mux, struct typec_mux_state *state)
>> +{
>> +	struct rockchip_typec_phy *tcphy = typec_mux_get_drvdata(mux);
>> +	struct typec_displayport_data *data;
>> +	int hpd = 0;
>> +
>> +	mutex_lock(&tcphy->lock);
>> +
>> +	switch (state->mode) {
>> +	case TYPEC_STATE_SAFE:
>> +		fallthrough;
>> +	case TYPEC_STATE_USB:
>> +		tcphy->new_mode = MODE_DFP_USB;
>> +		phy_set_bus_width(tcphy->phys[TYPEC_PHY_DP], 0);
>> +		break;
>> +	case TYPEC_DP_STATE_C:
>> +	case TYPEC_DP_STATE_E:
> You need to check that altmode->svid is DP before checking for these
> modes.

Okay, will fix in v6.


>
>> +		tcphy->new_mode = MODE_DFP_DP;
>> +		data = state->data;
>> +		hpd = !!(data->status & DP_STATUS_HPD_STATE);
>> +		phy_set_bus_width(tcphy->phys[TYPEC_PHY_DP], hpd ? 4 : 0);
>> +		break;
>> +	case TYPEC_DP_STATE_D:
>> +		tcphy->new_mode = MODE_DFP_DP | MODE_DFP_USB;
>> +		data = state->data;
>> +		hpd = !!(data->status & DP_STATUS_HPD_STATE);
>> +		phy_set_bus_width(tcphy->phys[TYPEC_PHY_DP], hpd ? 2 : 0);
>> +		break;
>> +	default:
>> +		break;
>> +	}
>> +
>> +	mutex_unlock(&tcphy->lock);
>> +
>> +	return 0;
>> +}
>> +

-- 
Best,
Chaoyi