[PATCH V2 3/3] dmaengine: xilinx_dma: Optimize control register write and channel start logic for AXIDMA and MCDMA in corresponding start_transfer()

[Folker Schwesinger]

On Fri Oct 3, 2025 at 8:19 AM CEST, Suraj Gupta wrote:
> Optimize AXI DMA control register programming by consolidating
> coalesce count and delay configuration into a single register write.
> Previously, the coalesce count was written separately from the delay
> configuration, resulting in two register writes. Combine these into
> one write operation to reduce bus overhead.
> Additionally, avoid redundant channel starts in xilinx_dma_start_transfer()
> and xilinx_mcdma_start_transfer() by only calling xilinx_dma_start() when
> the channel is actually idle.
>
> Signed-off-by: Suraj Gupta <suraj.gupta2 at amd.com>
> Co-developed-by: Srinivas Neeli <srinivas.neeli at amd.com>
> Signed-off-by: Srinivas Neeli <srinivas.neeli at amd.com>

For the AXIDMA code paths:

Tested-by: Folker Schwesinger <dev at folker-schwesinger.de>

> ---
>  drivers/dma/xilinx/xilinx_dma.c | 7 ++++---
>  1 file changed, 4 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/dma/xilinx/xilinx_dma.c b/drivers/dma/xilinx/xilinx_dma.c
> index aa6589e88c5c..a050b06e3b8d 100644
> --- a/drivers/dma/xilinx/xilinx_dma.c
> +++ b/drivers/dma/xilinx/xilinx_dma.c
> @@ -1561,7 +1561,6 @@ static void xilinx_dma_start_transfer(struct xilinx_dma_chan *chan)
>  		reg &= ~XILINX_DMA_CR_COALESCE_MAX;
>  		reg |= chan->desc_pendingcount <<
>  				  XILINX_DMA_CR_COALESCE_SHIFT;
> -		dma_ctrl_write(chan, XILINX_DMA_REG_DMACR, reg);
>  	}
>  
>  	if (chan->has_sg && list_empty(&chan->active_list))
> @@ -1571,7 +1570,8 @@ static void xilinx_dma_start_transfer(struct xilinx_dma_chan *chan)
>  	reg  |= chan->irq_delay << XILINX_DMA_CR_DELAY_SHIFT;
>  	dma_ctrl_write(chan, XILINX_DMA_REG_DMACR, reg);
>  
> -	xilinx_dma_start(chan);
> +	if (chan->idle)
> +		xilinx_dma_start(chan);
>  
>  	if (chan->err)
>  		return;
> @@ -1660,7 +1660,8 @@ static void xilinx_mcdma_start_transfer(struct xilinx_dma_chan *chan)
>  	reg |= XILINX_MCDMA_CR_RUNSTOP_MASK;
>  	dma_ctrl_write(chan, XILINX_MCDMA_CHAN_CR_OFFSET(chan->tdest), reg);
>  
> -	xilinx_dma_start(chan);
> +	if (chan->idle)
> +		xilinx_dma_start(chan);
>  
>  	if (chan->err)
>  		return;