[PATCH v1 2/3] arm64: dts: ti: var-som-am62p: Add support for WM8904 audio codec

[Stefano Radaelli]

The VAR-SOM-AM62P can integrate the WM8904, a high-performance
ultra-low-power stereo codec optimized for portable audio applications.

This patch adds the WM8904 device to the appropriate I2C bus, enables
the McASP1 peripheral, and introduces the sound node to expose the
sound card to the system.

Signed-off-by: Stefano Radaelli <stefano.radaelli21 at gmail.com>
---
 arch/arm64/boot/dts/ti/k3-am62p5-var-som.dtsi | 72 +++++++++++++++++++
 1 file changed, 72 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-am62p5-var-som.dtsi b/arch/arm64/boot/dts/ti/k3-am62p5-var-som.dtsi
index b93372f22732..aba72d0b767c 100644
--- a/arch/arm64/boot/dts/ti/k3-am62p5-var-som.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-am62p5-var-som.dtsi
@@ -112,6 +112,38 @@ reg_3v3_phy: regulator-3v3-phy {
 		enable-active-high;
 		regulator-always-on;
 	};
+
+	sound {
+		compatible = "simple-audio-card";
+		simple-audio-card,bitclock-master = <&codec_dai>;
+		simple-audio-card,format = "dsp_b";
+		simple-audio-card,frame-master = <&codec_dai>;
+		simple-audio-card,name = "wm8904-audio";
+		simple-audio-card,mclk-fs = <256>;
+		simple-audio-card,routing =
+			"Headphone Jack", "HPOUTL",
+			"Headphone Jack", "HPOUTR",
+			"IN2L", "Line In Jack",
+			"IN2R", "Line In Jack",
+			"IN1L", "Microphone Jack",
+			"IN1R", "Microphone Jack";
+		simple-audio-card,widgets =
+			"Microphone", "Microphone Jack",
+			"Headphone", "Headphone Jack",
+			"Line", "Line In Jack";
+
+		codec_dai: simple-audio-card,codec {
+			sound-dai = <&wm8904>;
+		};
+
+		simple-audio-card,cpu {
+			sound-dai = <&mcasp1>;
+		};
+	};
+};
+
+&audio_refclk1 {
+	assigned-clock-rates = <100000000>;
 };
 
 &cpsw3g {
@@ -149,6 +181,19 @@ &main_i2c2 {
 	pinctrl-0 = <&pinctrl_i2c2>;
 	clock-frequency = <400000>;
 	status = "okay";
+
+	wm8904: audio-codec at 1a {
+		compatible = "wlf,wm8904";
+		reg = <0x1a>;
+		#sound-dai-cells = <0>;
+		clocks = <&audio_refclk1>;
+		clock-names = "mclk";
+		AVDD-supply = <&reg_1v8>;
+		CPVDD-supply = <&reg_1v8>;
+		DBVDD-supply = <&reg_3v3>;
+		DCVDD-supply = <&reg_1v8>;
+		MICVDD-supply = <&reg_1v8>;
+	};
 };
 
 &main_i2c3 {
@@ -179,6 +224,16 @@ AM62PX_IOPAD(0x01d4, PIN_INPUT_PULLUP, 2) /* (C22) UART0_RTSn.I2C3_SDA */
 		>;
 	};
 
+	pinctrl_mcasp1: main-mcasp1-default-pins {
+		pinctrl-single,pins = <
+			AM62PX_IOPAD(0x0090, PIN_INPUT, 2) /* (U24) GPMC0_BE0n_CLE.MCASP1_ACLKX */
+			AM62PX_IOPAD(0x0098, PIN_INPUT, 2) /* (AA24) GPMC0_WAIT0.MCASP1_AFSX */
+			AM62PX_IOPAD(0x008c, PIN_OUTPUT, 2) /* (T25) GPMC0_WEn.MCASP1_AXR0 */
+			AM62PX_IOPAD(0x0084, PIN_INPUT, 2) /* (R25) GPMC0_ADVn_ALE.MCASP1_AXR2 */
+			AM62PX_IOPAD(0x00a0, PIN_OUTPUT, 1) /* (P24) GPMC0_WPn.AUDIO_EXT_REFCLK1 */
+		>;
+	};
+
 	pinctrl_mdio1: main-mdio1-default-pins {
 		pinctrl-single,pins = <
 			AM62PX_IOPAD(0x0160, PIN_OUTPUT, 0) /* (F17) MDIO0_MDC */
@@ -280,6 +335,23 @@ bluetooth {
 	};
 };
 
+&mcasp1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_mcasp1>;
+	op-mode = <0>;  /* MCASP_IIS_MODE */
+	serial-dir = <  /* 0: INACTIVE, 1: TX, 2: RX */
+		1 0 2 0
+		0 0 0 0
+		0 0 0 0
+		0 0 0 0
+	>;
+	tdm-slots = <2>;
+	tx-num-evt = <0>;
+	rx-num-evt = <0>;
+	#sound-dai-cells = <0>;
+	status = "okay";
+};
+
 &sdhci0 {
 	/* On-module eMMC */
 	ti,driver-strength-ohm = <50>;
-- 
2.47.3