[PATCH net-next] net: stmmac: dwmac: Disable flushing frames on Rx Buffer Unavailable

[Russell King (Oracle)]

On Wed, Nov 26, 2025 at 12:37:12AM +0800, Rohan G Thomas via B4 Relay wrote:
> From: Rohan G Thomas <rohan.g.thomas at altera.com>
> 
> In Store and Forward mode, flushing frames when the receive buffer is
> unavailable, can cause the MTL Rx FIFO to go out of sync. This results
> in buffering of a few frames in the FIFO without triggering Rx DMA
> from transferring the data to the system memory until another packet
> is received. Once the issue happens, for a ping request, the packet is
> forwarded to the system memory only after we receive another packet
> and hece we observe a latency equivalent to the ping interval.
> 
> 64 bytes from 192.168.2.100: seq=1 ttl=64 time=1000.344 ms
> 
> Also, we can observe constant gmacgrp_debug register value of
> 0x00000120, which indicates "Reading frame data".
> 
> The issue is not reproducible after disabling frame flushing when Rx
> buffer is unavailable. But in that case, the Rx DMA enters a suspend
> state due to buffer unavailability. To resume operation, software
> must write to the receive_poll_demand register after adding new
> descriptors, which reactivates the Rx DMA.


This seems like a sensible writeup, which all seems to make sense,
even though the databook I have seems vague on the effect of the
DFF bit.

> This issue is observed in the socfpga platforms which has dwmac1000 IP
> like Arria 10, Cyclone V and Agilex 7. Issue is reproducible after
> running iperf3 server at the DUT for UDP lower packet sizes.
> 
> Signed-off-by: Rohan G Thomas <rohan.g.thomas at altera.com>
> Reviewed-by: Matthew Gerlach <matthew.gerlach at altera.com>

Given the above, that Maxime has also tested it which shows a net
benefit, and I've looked through this, even though I can't positively
say it's correct due to the databook vagueness:

Reviewed-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>

Thanks!

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!