[PATCH v5 3/3] arm64: dts: qcom: monaco-evk-camera: Add DT overlay

[Konrad Dybcio]

On 11/14/25 7:45 AM, Vikram Sharma wrote:
> From: Nihal Kumar Gupta <quic_nihalkum at quicinc.com>
> 
> Monaco EVK board does not include a camera sensor in its default hardware
> configuration. Introducing a device tree overlay to support optional
> integration of the IMX577 sensor via CSIPHY1.
> 
> Camera reset is handled through an I2C expander, and power is enabled
> via TLMM GPIO74.

[...]

> +&{/} {
> +	vreg_cam1_2p8: vreg-cam1-2p8 {

Where does this regulator lie physically? Is its presence dependent
on the connection of the sensor, is it part of the EVK carrier board,
or perhaps something else?

> +		compatible = "regulator-fixed";
> +		regulator-name = "vreg_cam1_2p8";
> +		startup-delay-us = <10000>;
> +		enable-active-high;
> +		gpio = <&tlmm 74 GPIO_ACTIVE_HIGH>;
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&cam1_avdd_2v8_en_default>;

property-n
property-names

please

[...]

> +&tlmm {
> +	/*
> +	 * gpio67, gpio68, gpio69 provide MCLK0, MCLK1, MCLK2 for
> +	 * CAM0, CAM1 and CAM2 respectively via the "cam_mclk" function.
> +	 * So, here it's MCLK1 pin for instance.
> +	 */

I don't really see the value in these comments..

Vladimir requested you to move the 'description' (meaning the node
describing the hardware, not a comment explaining the function of the
DT hunk in natural language) to monaco.dtsi too

Konrad