[PATCH] PCI: cadence: Kconfig: change PCIE_CADENCE configs from tristate to bool

[Arnd Bergmann]

On Fri, Nov 14, 2025, at 06:47, Siddharth Vadapalli wrote:
> On Thu, 2025-11-13 at 11:13 +0100, Arnd Bergmann wrote:
>> On Thu, Nov 13, 2025, at 10:27, Siddharth Vadapalli wrote:

> Thank you for the suggestion. I think that the following Makefile changes
> will be sufficient and Kconfig doesn't need to be modified:
>
> diff --git a/drivers/pci/controller/cadence/Makefile
> b/drivers/pci/controller/cadence/Makefile
> index 5e23f8539ecc..1a97c9b249b8 100644
> --- a/drivers/pci/controller/cadence/Makefile
> +++ b/drivers/pci/controller/cadence/Makefile
> @@ -4,4 +4,6 @@ obj-$(CONFIG_PCIE_CADENCE_HOST) += pcie-cadence-host.o
>  obj-$(CONFIG_PCIE_CADENCE_EP) += pcie-cadence-ep.o
>  obj-$(CONFIG_PCIE_CADENCE_PLAT) += pcie-cadence-plat.o
>  obj-$(CONFIG_PCI_J721E) += pci-j721e.o
> +pci_j721e-y := pci-j721e.o pcie-cadence.o
>  obj-$(CONFIG_PCIE_SG2042_HOST) += pcie-sg2042.o
> +pci_sg2042_host-y := pci-sg2042.o pcie-cadence.o
>
> If either of PCI_J721E or SG2042_HOST is selected as a built-in module,
> then pcie-cadence-host.c, pcie-cadence-ep.c and pcie-cadence.c drivers will
> be built-in. If both PCI_J721E and SG2042_HOST are selected as loadable
> modules, only then the library drivers will be enabled as loadable modules.
>
> Please let me know what you think.

I don't think that the version above does what you want,
this would build the pcie-cadence.o file into three separate
modules and break in additional ways if a subset of them are
built-in.

I would still suggest combining pcie-cadence{,-ep,-host}.o into
one module that is used by the other drivers, as that would address
the build failure you are observing.

An alternative would be to change the pcie-j721e.c file to only
reference the host portion if host support is enabled for this
driver.

      Arnd