[PATCH v4 4/8] reset: imx8mp-audiomix: Drop unneeded macros

[Philipp Zabel]

On Di, 2025-11-04 at 04:02 -0800, Laurentiu Mihalcea wrote:
> From: Laurentiu Mihalcea <laurentiu.mihalcea at nxp.com>
> 
> The macros defining the mask values for the EARC, EARC PHY resets,
> and the DSP RUN_STALL signal can be dropped as they are not and will
> not be used anywhere else except to set the value of the "mask" field
> from "struct imx8mp_reset_map". In this particular case, based on the
> name of the "mask" field, you can already deduce what these values are
> for, which is why defining macros for them doesn't offer any new
> information, nor does it help with the code readability.
> 
> Reviewed-by: Daniel Baluta <daniel.baluta at nxp.com>
> Reviewed-by: Frank Li <Frank.Li at nxp.com>
> Signed-off-by: Laurentiu Mihalcea <laurentiu.mihalcea at nxp.com>
> ---
>  drivers/reset/reset-imx8mp-audiomix.c | 10 +++-------
>  1 file changed, 3 insertions(+), 7 deletions(-)
> 
> diff --git a/drivers/reset/reset-imx8mp-audiomix.c b/drivers/reset/reset-imx8mp-audiomix.c
> index eceb37ff5dc5..e9643365a62c 100644
> --- a/drivers/reset/reset-imx8mp-audiomix.c
> +++ b/drivers/reset/reset-imx8mp-audiomix.c
> @@ -14,11 +14,7 @@
>  #include <linux/reset-controller.h>
>  
>  #define IMX8MP_AUDIOMIX_EARC_RESET_OFFSET	0x200
> -#define IMX8MP_AUDIOMIX_EARC_RESET_MASK		BIT(0)
> -#define IMX8MP_AUDIOMIX_EARC_PHY_RESET_MASK	BIT(1)
> -
>  #define IMX8MP_AUDIOMIX_DSP_RUNSTALL_OFFSET	0x108
> -#define IMX8MP_AUDIOMIX_DSP_RUNSTALL_MASK	BIT(5)
>  
>  struct imx8mp_reset_map {
>  	unsigned int offset;
> @@ -29,17 +25,17 @@ struct imx8mp_reset_map {
>  static const struct imx8mp_reset_map reset_map[] = {
>  	[IMX8MP_AUDIOMIX_EARC_RESET] = {
>  		.offset	= IMX8MP_AUDIOMIX_EARC_RESET_OFFSET,
> -		.mask	= IMX8MP_AUDIOMIX_EARC_RESET_MASK,
> +		.mask = BIT(0),

Since the masks are all single-bit, and you make that mandatory in the
next patch, I suggest storing the bit offset in the reset map instead:

-		.mask	= IMX8MP_AUDIOMIX_EARC_RESET_MASK,
+		.bit = 0,

and so on. That way it's clear that no reset control ever manipulates
multiple bits at the same time.

Either way, either in this patch or the next, add an

  #include <linux/bits.h>

for BIT().

regards
Philipp