[PATCH net-next 01/11] net: stmmac: imx: use phylink's interface mode for set_clk_tx_rate()

[Russell King (Oracle)]

imx_dwmac_set_clk_tx_rate() is passed the interface mode from phylink
which will be the same as plat_dat->phy_interface. Use the passed-in
interface mode rather than plat_dat->phy_interface.

Signed-off-by: Russell King (Oracle) <rmk+kernel at armlinux.org.uk>
---
 drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
index 4268b9987237..147fa08d5b6e 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-imx.c
@@ -195,9 +195,6 @@ static void imx_dwmac_exit(struct platform_device *pdev, void *priv)
 static int imx_dwmac_set_clk_tx_rate(void *bsp_priv, struct clk *clk_tx_i,
 				     phy_interface_t interface, int speed)
 {
-	struct imx_priv_data *dwmac = bsp_priv;
-
-	interface = dwmac->plat_dat->phy_interface;
 	if (interface == PHY_INTERFACE_MODE_RMII ||
 	    interface == PHY_INTERFACE_MODE_MII)
 		return 0;
-- 
2.47.3