[PATCH net-next 0/3] net: stmmac: phylink PCS conversion part 3 (dodgy stuff)

[Russell King (Oracle)]

On Mon, Nov 03, 2025 at 02:28:24PM +0530, Mohd Ayaan Anwar wrote:
> On Thu, Oct 30, 2025 at 03:22:12PM +0000, Russell King (Oracle) wrote:
> > On Thu, Oct 30, 2025 at 03:19:27PM +0000, Russell King (Oracle) wrote:
> > > > 
> > > > This is probably fine since Bit(9) is self-clearing and its value just
> > > > after this is 0x00041000.
> > > 
> > > Yes, and bit 9 doesn't need to be set at all. SGMII isn't "negotiation"
> > > but the PHY says to the MAC "this is how I'm operating" and the MAC says
> > > "okay". Nothing more.
> > > 
> > > I'm afraid the presence of snps,ps-speed, this disrupts the test.
> > 
> > Note also that testing a 10M link, 100M, 1G and finally 100M again in
> > that order would also be interesting given my question about the RGMII
> > register changes that configure_sgmii does.
> > 
> 
> Despite several attempts, I couldn't get 10M to work. There is a link-up
> but the data path is broken. I checked the net-next tip and it's broken
> there as well.
> 
> Oddly enough, configure_sgmii is called with its speed argument set to
> 1000:
> [   12.305488] qcom-ethqos 23040000.ethernet eth0: phy link up sgmii/10Mbps/Half/pause/off/nolpi
> [   12.315233] qcom-ethqos 23040000.ethernet eth0: major config, requested phy/sgmii
> [   12.322965] qcom-ethqos 23040000.ethernet eth0: interface sgmii inband modes: pcs=00 phy=03
> [   12.331586] qcom-ethqos 23040000.ethernet eth0: major config, active phy/outband/sgmii
> [   12.339738] qcom-ethqos 23040000.ethernet eth0: phylink_mac_config: mode=phy/sgmii/pause adv=0000000,00000000,00000000,00000000 pause=00
> [   12.355113] qcom-ethqos 23040000.ethernet eth0: ethqos_configure_sgmii : Speed = 1000
> [   12.363196] qcom-ethqos 23040000.ethernet eth0: Link is Up - 10Mbps/Half - flow control off

If you have "rate matching" enabled (signified by "pause" in the mode=
part of phylink_mac_config), then the MAC gets told the maximum speed for
the PHY interface, which for Cisco SGMII is 1G. This is intentional to
support PHYs that _really_ do use rate matching. Your PHY isn't using it,
and rate matching for SGMII is pointless.

Please re-run testing with phy-mode = "sgmii" which you've tested
before without your rate-matching patch to the PHY driver, so the
system knows the _correct_ parameters for these speeds.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 80Mbps down 10Mbps up. Decent connectivity at last!