[PATCH 6/6] arm64: dts: rockchip: update 100ASK DshanPi A1 support

[Chukun Pan]

Enable button, RTC and USB support for the 100ASK DshanPi A1 board.

Signed-off-by: Chukun Pan <amadeus at jmu.edu.cn>
---
 .../dts/rockchip/rk3576-100ask-dshanpi-a1.dts | 94 +++++++++++++++++++
 1 file changed, 94 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/rk3576-100ask-dshanpi-a1.dts b/arch/arm64/boot/dts/rockchip/rk3576-100ask-dshanpi-a1.dts
index 815f75e7cd70..f325adf348ce 100644
--- a/arch/arm64/boot/dts/rockchip/rk3576-100ask-dshanpi-a1.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3576-100ask-dshanpi-a1.dts
@@ -7,6 +7,7 @@
 /dts-v1/;
 
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
 #include <dt-bindings/leds/common.h>
 #include <dt-bindings/pinctrl/rockchip.h>
 #include <dt-bindings/soc/rockchip,vop2.h>
@@ -66,6 +67,61 @@ hdmi_con_in: endpoint {
 		};
 	};
 
+	keys-0 {
+		compatible = "adc-keys";
+		io-channels = <&saradc 0>;
+		io-channel-names = "buttons";
+		keyup-threshold-microvolt = <1800000>;
+		poll-interval = <100>;
+
+		button-maskrom {
+			label = "MASKROM";
+			linux,code = <KEY_SETUP>;
+			press-threshold-microvolt = <0>;
+		};
+	};
+
+	keys-1 {
+		compatible = "adc-keys";
+		io-channels = <&saradc 1>;
+		io-channel-names = "buttons";
+		keyup-threshold-microvolt = <1800000>;
+		poll-interval = <100>;
+
+		button-recovery {
+			label = "RECOVERY";
+			linux,code = <KEY_VENDOR>;
+			press-threshold-microvolt = <0>;
+		};
+	};
+
+	keys-2 {
+		compatible = "adc-keys";
+		io-channels = <&saradc 4>;
+		io-channel-names = "buttons";
+		keyup-threshold-microvolt = <1800000>;
+		poll-interval = <100>;
+
+		button-user2 {
+			label = "USER2";
+			linux,code = <BTN_2>;
+			press-threshold-microvolt = <0>;
+		};
+	};
+
+	keys-3 {
+		compatible = "gpio-keys";
+		pinctrl-names = "default";
+		pinctrl-0 = <&gpio0_a0_d>;
+
+		button-user1 {
+			gpios = <&gpio0 RK_PA0 GPIO_ACTIVE_LOW>;
+			label = "USER1";
+			linux,code = <BTN_1>;
+			wakeup-source;
+		};
+	};
+
 	vcc_in: regulator-vcc-12v0-dcin {
 		compatible = "regulator-fixed";
 		regulator-name = "vcc_in";
@@ -599,6 +655,15 @@ regulator-state-mem {
 	};
 };
 
+&i2c2 {
+	status = "okay";
+
+	rtc at 68 {
+		compatible = "dallas,ds1338";
+		reg = <0x68>;
+	};
+};
+
 &i2c4 {
 	status = "okay";
 
@@ -618,6 +683,11 @@ es8388: audio-codec at 11 {
 	};
 };
 
+&i2c9 {
+	pinctrl-0 = <&i2c9m1_xfer>;
+	status = "okay";
+};
+
 &mdio0 {
 	rgmii_phy0: phy at 0 {
 		compatible = "ethernet-phy-ieee802.3-c22";
@@ -661,6 +731,12 @@ gmac1_rst: gmac1-rst {
 		};
 	};
 
+	gpio-keys {
+		gpio0_a0_d: gpio0-a0-d {
+			rockchip,pins = <0 RK_PA0 RK_FUNC_GPIO &pcfg_pull_up>;
+		};
+	};
+
 	headphone {
 		hp_det: hp-det {
 			rockchip,pins = <0 RK_PA2 RK_FUNC_GPIO &pcfg_pull_none>;
@@ -688,6 +764,11 @@ &sai6 {
 	status = "okay";
 };
 
+&saradc {
+	vref-supply = <&vcca1v8_pldo2_s0>;
+	status = "okay";
+};
+
 &sdhci {
 	bus-width = <8>;
 	full-pwr-cycle-in-suspend;
@@ -733,6 +814,19 @@ &uart0 {
 	status = "okay";
 };
 
+&usbdp_phy {
+	status = "okay";
+};
+
+&usb_drd0_dwc3 {
+	status = "okay";
+};
+
+&usb_drd1_dwc3 {
+	dr_mode = "host";
+	status = "okay";
+};
+
 &vop {
 	status = "okay";
 };
-- 
2.25.1