[PATCH 09/10] PCI: exynos: Add support for Tesla FSD SoC

[Shradha Todi]

> -----Original Message-----
> From: Krzysztof Kozlowski <krzk at kernel.org>
> Sent: 21 May 2025 15:18
> To: Shradha Todi <shradha.t at samsung.com>
> Cc: linux-pci at vger.kernel.org; devicetree at vger.kernel.org; linux-arm-kernel at lists.infradead.org; linux-samsung-soc at vger.kernel.or;
> linux-kernel at vger.kernel.org; linux-phy at lists.infradead.org; manivannan.sadhasivam at linaro.org; lpieralisi at kernel.org;
> kw at linux.com; robh at kernel.org; bhelgaas at google.com; jingoohan1 at gmail.com; krzk+dt at kernel.org; conor+dt at kernel.org;
> alim.akhtar at samsung.com; vkoul at kernel.org; kishon at kernel.org; arnd at arndb.de; m.szyprowski at samsung.com;
> jh80.chung at samsung.com
> Subject: Re: [PATCH 09/10] PCI: exynos: Add support for Tesla FSD SoC
> 
> On Mon, May 19, 2025 at 01:01:51AM GMT, Shradha Todi wrote:
> >  static int exynos_pcie_probe(struct platform_device *pdev)  {
> >  	struct device *dev = &pdev->dev;
> > @@ -355,6 +578,26 @@ static int exynos_pcie_probe(struct platform_device *pdev)
> >  	if (IS_ERR(ep->phy))
> >  		return PTR_ERR(ep->phy);
> >
> > +	if (ep->pdata->soc_variant == FSD) {
> > +		ret = dma_set_mask_and_coherent(dev, DMA_BIT_MASK(36));
> > +		if (ret)
> > +			return ret;
> > +
> > +		ep->sysreg = syscon_regmap_lookup_by_phandle(dev->of_node,
> > +				"samsung,syscon-pcie");
> > +		if (IS_ERR(ep->sysreg)) {
> > +			dev_err(dev, "sysreg regmap lookup failed.\n");
> > +			return PTR_ERR(ep->sysreg);
> > +		}
> > +
> > +		ret = of_property_read_u32_index(dev->of_node, "samsung,syscon-pcie", 1,
> > +						 &ep->sysreg_offset);
> > +		if (ret) {
> > +			dev_err(dev, "couldn't get the register offset for syscon!\n");
> 
> So all MMIO will go via syscon? I am pretty close to NAKing all this, but let's be sure that I got it right - please post your complete DTS
> for upstream. That's a requirement from me for any samsung drivers - I don't want to support fake, broken downstream solutions
> (based on multiple past submissions).
> 

By all MMIO do you mean DBI read/write? The FSD hardware architecture is such that the DBI/ATU/DMA address is at the same offset.
The syscon register holds the upper bits of the actual address differentiating between these 3 spaces. This kind of implementation was done
to reduce address space for PCI DWC controller. So yes, each DBI/ATU register read/write will have syscon write before it to switch address space.

> Best regards,
> Krzysztof