[PATCH v3 1/2] arm64: dts: amlogic: Update USB hub power and reset properties

[Anand Moon]

Add missing reset-gpios property to the USB 2.0 hub node to
ensure proper reset handling. Also update the vdd-supply for
both USB 2.0 and 3.0 hubs to use the shared hub_5v regulator
for consistent power management.

Fixes: ccff36934137 ("arm64: dts: amlogic: Used onboard usb hub reset on odroid n2")
Signed-off-by: Anand Moon <linux.amoon at gmail.com>
---
v3: dropped remove of usb2_phy1.
v2: remove usb2_phy1 phy-supply since now it's managed by
the hub reset control.
---
 arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
index 3bca8023638d4..ad959f8bc1acd 100644
--- a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
@@ -42,7 +42,8 @@ hub_2_0: hub at 1 {
 			compatible = "usb5e3,610";
 			reg = <1>;
 			peer-hub = <&hub_3_0>;
-			vdd-supply = <&usb_pwr_en>;
+			reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
+			vdd-supply = <&hub_5v>;
 		};
 
 		/* 3.0 hub on port 4 */
@@ -51,7 +52,7 @@ hub_3_0: hub at 2 {
 			reg = <2>;
 			peer-hub = <&hub_2_0>;
 			reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
-			vdd-supply = <&vcc_5v>;
+			vdd-supply = <&hub_5v>;
 		};
 	};
 

base-commit: 5cdb2c77c4c3d36bdee83d9231649941157f8204
-- 
2.49.0