[PATCH] mailbox: imx: Fix TXDB_V2 sending

[Jassi Brar]

On Thu, Apr 24, 2025 at 8:51 PM Peng Fan (OSS) <peng.fan at oss.nxp.com> wrote:
>
> From: Peng Fan <peng.fan at nxp.com>
>
> i.MX95 features several processing domains, Cortex-M7, Cortex-A55
> secure, Cortex-A55 non-secure. Each domain could communicate with
> SCMI firmware with a dedicated MU. But the current NXP SCMI firmware
> is not a RTOS, all processing logic codes are in interrupt context.
> So if high priority Cortex-M7 is communicating with SCMI firmware and
> requires a bit more time to handle the SCMI call, Linux MU TXDB_V2
> will be timeout with high possiblity in 1000us(the current value in
> imx-mailbox.c). Per NXP SCMI firmware design, if timeout, there is
> no recover logic, so SCMI agents should never timeout and always
> wait until the check condition met.
>
> Based on the upper reason, enlarge the timeout value to 10ms which
> is less chance to timeout, and retry if timeout really happends.
>
> Fixes: 5bfe4067d350 ("mailbox: imx: support channel type tx doorbell v2")
> Signed-off-by: Peng Fan <peng.fan at nxp.com>
> ---
>  drivers/mailbox/imx-mailbox.c | 21 +++++++++++++++------
>  1 file changed, 15 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/mailbox/imx-mailbox.c b/drivers/mailbox/imx-mailbox.c
> index 6ef8338add0d..aef8d572a27c 100644
> --- a/drivers/mailbox/imx-mailbox.c
> +++ b/drivers/mailbox/imx-mailbox.c
> @@ -226,7 +226,7 @@ static int imx_mu_generic_tx(struct imx_mu_priv *priv,
>  {
>         u32 *arg = data;
>         u32 val;
> -       int ret;
> +       int ret, count;
>
>         switch (cp->type) {
>         case IMX_MU_TYPE_TX:
> @@ -240,11 +240,20 @@ static int imx_mu_generic_tx(struct imx_mu_priv *priv,
>         case IMX_MU_TYPE_TXDB_V2:
>                 imx_mu_write(priv, IMX_MU_xCR_GIRn(priv->dcfg->type, cp->idx),
>                              priv->dcfg->xCR[IMX_MU_GCR]);
> -               ret = readl_poll_timeout(priv->base + priv->dcfg->xCR[IMX_MU_GCR], val,
> -                                        !(val & IMX_MU_xCR_GIRn(priv->dcfg->type, cp->idx)),
> -                                        0, 1000);
> -               if (ret)
> -                       dev_warn_ratelimited(priv->dev, "channel type: %d failure\n", cp->type);
> +               ret = -ETIMEDOUT;
> +               count = 0;
> +               while (ret) {

Maybe    while (ret && count < N)  ... esp when you already increase
the timeout from 1 to 10ms.

cheers.