[PATCH v5 0/7] MT9M114 driver bugfix and improvements

[Mathis Foerst]

Hi,

this patch series contains the following bugfix and improvements
for the MT9M114 camera driver:

Changelog:

v4 -> v5:
- Apply reformatings and small refactorings as suggested in review comments
- Split PATCH 4 into two parts: One for applying HFLIP / VFLIP while 
  streaming, one for applying set_selection while streaming.
- Add condition to apply set_selection immediately only if the size of the
  cropping rectangle does not change in PATCH 5
- Use device_property_read_u32 instead of of_property_read_u32 in PATCH 7

v3 -> v4:
- Rename DT binding from "onnn,slew-rate" to "slew-rate" in PATCH 1 and 6 as
  requested in the review comment.

v2 -> v3:
- Dropped PATCH 2 ("media: mt9m114: Add get_mbus_config").
  Based on the comments, this issure won't be fixed in the MT9M114
  driver but in "imx-media-csi.c" in a separate patch.
- Renumbered patches accordingly.
- Fix the incomplete renaming of the DT property from 'pad-slew-rate'
  to 'onnn,slew-rate' in PATCH 1 and 6.
- Fix checkpatch formatting suggestions in PATCH 2 and 6.

v1 -> v2:
- Fix the subjects of the patches
- Dropped PATCH 1 ("Add bypass-pll DT-binding") as it can be automatically
  detected if the PLL should be bypassed.
- Renumbered patches accordingly
- Switch to uint32, add default value and clarify documentation in PATCH 1
- Add 'Fixes' and 'Cc' tags as suggested in PATCH 6

Link to v1 discussion:
https://lore.kernel.org/linux-media/20250226153929.274562-1-mathis.foerst@mt.com/
Link to v2 discussion:
https://lore.kernel.org/linux-media/20250304103647.34235-1-mathis.foerst@mt.com/
Link to v3 discussion:
https://lore.kernel.org/linux-media/20250305101453.708270-1-mathis.foerst@mt.com/
Link to v4 discussion:
https://lore.kernel.org/linux-media/20250307093140.370061-1-mathis.foerst@mt.com/


Bugfixes:
- Fix a deadlock when using the V4L2 pad-ops get/set_frame_interval

New Features:
- Bypass the internal PLL if EXTCLK matches the configured link_frequency
- Make the slew-rate of the output pads configurable via DT
- Allow to change the cropping configuration and the horizontal/vertical
  flipping while the sensor is in streaming state

Thanks,
Mathis

Mathis Foerst (7):
  media: dt-bindings: mt9m114: Add slew-rate DT-binding
  media: mt9m114: Bypass PLL if required
  media: mt9m114: Factor out mt9m114_configure_pa
  media: mt9m114: Apply horizontal / vertical flip while streaming
  media: mt9m114: Allow set_selection while streaming
  media: mt9m114: Fix deadlock in get_frame_interval/set_frame_interval
  media: mt9m114: Set pad-slew-rate

 .../bindings/media/i2c/onnn,mt9m114.yaml      |   9 +
 drivers/media/i2c/mt9m114.c                   | 264 ++++++++++++------
 2 files changed, 185 insertions(+), 88 deletions(-)

base-commit: d608703fcdd9e9538f6c7a0fcf98bf79b1375b60
-- 
2.34.1