[PATCH 2/2] arm64: dts: rockchip: support Ethernet Switch adapter for RK3588 Jaguar

[Andrew Lunn]

> +&gmac1 {
> +	clock_in_out = "output";
> +	phy-mode = "rgmii";

Does the PCB have extra long clock lines to implement the 2ns delays?

> +	pinctrl-names = "default";
> +	pinctrl-0 = <&gmac1_rx_bus2
> +		     &gmac1_tx_bus2
> +		     &gmac1_rgmii_clk
> +		     &gmac1_rgmii_bus
> +		     &eth1_pins>;
> +	rx_delay = <0x30>;
> +	tx_delay = <0x30>;

Since this has a switch on the other end, its a bit more complicated
with RGMII delays. Normally, the MAC does nothing and passed rgmii-id
to the PHY, and the PHY then does the delays. However, here you don't
have a PHY. So you have the MAC add the delays. This looks O.K. I
would prefer that the driver used the standardized
rx-internal-delay-ps & tx-internal-delay-ps rather than these vendor
properties. But that is probably out of scope for this patchset.

> +			port at 5 {
> +				reg = <5>;
> +				ethernet = <&gmac1>;
> +				label = "CPU";
> +				phy-mode = "rgmii";

Again, this probably should be rgmii-id to correctly describe the PCB,
but i don't know if the switch takes any notice of it.

	Andrew