[PATCH v1] arm64: dts: amlogic: Update USB hub power and reset properties

[Neil Armstrong]

On 20/05/2025 11:18, Anand Moon wrote:
> Add missing reset-gpios property to the USB 2.0 hub node to
> ensure proper reset handling. Also update the vdd-supply for
> both USB 2.0 and 3.0 hubs to use the shared hub_5v regulator
> for consistent power management.
> 
> Fixes: ccff36934137 ("arm64: dts: amlogic: Used onboard usb hub reset on odroid n2")
> Signed-off-by: Anand Moon <linux.amoon at gmail.com>
> ---
>   arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi | 5 +++--
>   1 file changed, 3 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> index 3bca8023638d..ad959f8bc1ac 100644
> --- a/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> +++ b/arch/arm64/boot/dts/amlogic/meson-g12b-odroid-n2.dtsi
> @@ -42,7 +42,8 @@ hub_2_0: hub at 1 {
>   			compatible = "usb5e3,610";
>   			reg = <1>;
>   			peer-hub = <&hub_3_0>;
> -			vdd-supply = <&usb_pwr_en>;
> +			reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
> +			vdd-supply = <&hub_5v>;
>   		};
>   
>   		/* 3.0 hub on port 4 */
> @@ -51,7 +52,7 @@ hub_3_0: hub at 2 {
>   			reg = <2>;
>   			peer-hub = <&hub_2_0>;
>   			reset-gpios = <&gpio GPIOH_4 GPIO_ACTIVE_LOW>;
> -			vdd-supply = <&vcc_5v>;
> +			vdd-supply = <&hub_5v>;

In this case, also remove the &usb2_phy1 phy-supply since now it's managed by the hub reset control.

Neil

>   		};
>   	};
>   
> 
> base-commit: a5806cd506af5a7c19bcd596e4708b5c464bfd21