[PATCH 2/4] pmdomain: ti: Fix STANDBY handling of PER power domain

[Ulf Hansson]

On Wed, 19 Mar 2025 at 00:00, Sukrut Bellary <sbellary at baylibre.com> wrote:
>
> Per AM335x TRM[1](section 8.1.4.3 Power mode), in case of STANDBY,
> PER domain should be ON. So, fix the PER power domain handling on standby.
>
> [1] https://www.ti.com/lit/ug/spruh73q/spruh73q.pdf
>
> Signed-off-by: Sukrut Bellary <sbellary at baylibre.com>

Applied for next, thanks!

Kind regards
Uffe


> ---
>  drivers/pmdomain/ti/omap_prm.c | 8 ++++++--
>  1 file changed, 6 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/pmdomain/ti/omap_prm.c b/drivers/pmdomain/ti/omap_prm.c
> index b8ceb3c2b81c..7e36e675a8c6 100644
> --- a/drivers/pmdomain/ti/omap_prm.c
> +++ b/drivers/pmdomain/ti/omap_prm.c
> @@ -18,7 +18,9 @@
>  #include <linux/pm_domain.h>
>  #include <linux/reset-controller.h>
>  #include <linux/delay.h>
> -
> +#if IS_ENABLED(CONFIG_SUSPEND)
> +#include <linux/suspend.h>
> +#endif
>  #include <linux/platform_data/ti-prm.h>
>
>  enum omap_prm_domain_mode {
> @@ -88,6 +90,7 @@ struct omap_reset_data {
>  #define OMAP_PRM_HAS_RSTST     BIT(1)
>  #define OMAP_PRM_HAS_NO_CLKDM  BIT(2)
>  #define OMAP_PRM_RET_WHEN_IDLE BIT(3)
> +#define OMAP_PRM_ON_WHEN_STANDBY       BIT(4)
>
>  #define OMAP_PRM_HAS_RESETS    (OMAP_PRM_HAS_RSTCTRL | OMAP_PRM_HAS_RSTST)
>
> @@ -404,7 +407,8 @@ static const struct omap_prm_data am3_prm_data[] = {
>                 .name = "per", .base = 0x44e00c00,
>                 .pwrstctrl = 0xc, .pwrstst = 0x8, .dmap = &omap_prm_noinact,
>                 .rstctrl = 0x0, .rstmap = am3_per_rst_map,
> -               .flags = OMAP_PRM_HAS_RSTCTRL, .clkdm_name = "pruss_ocp"
> +               .flags = OMAP_PRM_HAS_RSTCTRL | OMAP_PRM_ON_WHEN_STANDBY,
> +               .clkdm_name = "pruss_ocp",
>         },
>         {
>                 .name = "wkup", .base = 0x44e00d00,
> --
> 2.34.1
>