[PATCH 6/8] dts: arm64: amlogic: add S7 pinctrl node

[Xianwei Zhao]

Hi Rob,
    Thanks for your reply.

On 2025/5/14 21:10, Rob Herring wrote:
> [ EXTERNAL EMAIL ]
> 
> On Wed, May 14, 2025 at 03:01:33PM +0800, Xianwei Zhao wrote:
>> Add pinctrl device to support Amlogic S7.
>>
>> Signed-off-by: Xianwei Zhao <xianwei.zhao at amlogic.com>
>> ---
>>   arch/arm64/boot/dts/amlogic/amlogic-s7.dtsi | 81 +++++++++++++++++++++++++++++
>>   1 file changed, 81 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/amlogic/amlogic-s7.dtsi b/arch/arm64/boot/dts/amlogic/amlogic-s7.dtsi
>> index f0c172681bd1..924f10aff269 100644
>> --- a/arch/arm64/boot/dts/amlogic/amlogic-s7.dtsi
>> +++ b/arch/arm64/boot/dts/amlogic/amlogic-s7.dtsi
>> @@ -6,6 +6,7 @@
>>   #include <dt-bindings/interrupt-controller/irq.h>
>>   #include <dt-bindings/interrupt-controller/arm-gic.h>
>>   #include <dt-bindings/gpio/gpio.h>
>> +#include <dt-bindings/pinctrl/amlogic,pinctrl.h>
>>
>>   / {
>>        cpus {
>> @@ -94,6 +95,86 @@ uart_b: serial at 7a000 {
>>                                clock-names = "xtal", "pclk", "baud";
>>                                status = "disabled";
>>                        };
>> +
>> +                     periphs_pinctrl: pinctrl {
> 
> If you have non-boolean ranges, then this should have a unit address
> (@4000).
> 

Will add a unit address for node.

>> +                             compatible = "amlogic,pinctrl-s7";
>> +                             #address-cells = <2>;
>> +                             #size-cells = <2>;
> 
> Doesn't look like you need 64-bits of address and size. 1 cell is
> enough.
> 

Krzysztof raised this question in the definition of binding stage.
https://lore.kernel.org/all/012cfaca-e8f5-4614-9393-a4a46a797adb@amlogic.com/

>> +                             ranges = <0x0 0x0 0x0 0x4000 0x0 0x340>;
>